Abstract:In power engineering, analysis of the thermal behavior of steam turbine and development of control strategies depend on online evaluations of the temperature fields of in-service components. Due to the complexity of structure and the variability of operating conditions, an online reconstruction technique fused with proper orthogonal decomposition (POD) and sparse sensor data is described herein to monitor the three-dimensional (3D) transient temperature fields of a steam turbine casing. The POD-based reduced order approach was driven by the high-fidelity data of the steam turbine under several start-up conditions, and the POD was used to extract a reduced set of vectors in the orthogonal basis to capture the spatial distribution modes of 3D temperature field. As a result, the temperature fields of steam turbine casing can be reconstructed using the reduced set of vectors in the orthogonal POD basis and the corresponding coefficients, and then it is feasible to online monitor the global temperature distribution by minimizing deviations between the predicted and measured temperatures. The feasibility and accuracy of the reconstruction approach were demonstrated using two numerical examples in comparison with high fidelity data. Finally, real sensor-measured sequential temperatures were used to dynamically determine the real temperature field of the casing. Notably, the reconstructed temperatures were highly consistent with the sensor-measured temperatures, and the time delay of almost every reconstruction process was less than 0.02 s. This proposed reconstruction approach can provide reliable online monitoring for the transient temperature fields of a 3D complex component based on sparse sensors, and it will provide effective support for the design, operation and maintenance.

RECONSTRUCTION FOR FUEL SIGNAL OF ONCE-THROUGH BOILER BASED ON DISTRIBUTED DATA FUSION

The Application of Fuzzy Pattern Fusion Based on Competitive Agglomeration in Coal-Fired Boiler Operation Optimization.

A DATA FUSION METHOD FOR ON-LINE PERFORMANCE CALCULATION OF TURBOGENERATOR

A Novel Fuzzy Fusion Method Based Deviation and Its Application on Furnace

On-line Tracking of Pulverized Coal and Biomass Fuels Through Flame Spectrum Analysis

Unit Load and Combustion Control Optimization Based on Radiation Energy Signals

The Gas Mass Flow Measurement Base on Multi-Sensor Information Fusion

Combustion Optimization Technique of Boiler Based on Information Fusion

RESEARCH ON RECONSTRUCTION OF TEMPERATURE FIELD IN FURNACE AND NONLINEAR OPTIMIZATION METHOD

Boiler Furnace Temperature Field Measurement and Reconstruction Error Elimination Based on Temperature Field Residual Correction Network

Hybrid Neural Network in Circulating Fluidized Bed Boiler Based on Information Fusion Clustering Control

Modified reconstruction of boiler numerical temperature field based on flame image feature extraction

300MW BOILER QUASI-THREE-DIMENSIONAL TEMPERATURE FIELD FAST RECONSTRUCTION BASED ON INTERPOLATED FILTER BACK PROJECTION METHOD

Four-Stage Multi-Physics Simulations to Assist Temperature Sensor Design for Industrial-Scale Coal-Fired Boiler

Online monitoring instantaneous 2D temperature distributions in a furnace using acoustic tomography based on frequency division multiplexing

APPLICATION OF COMBUSTION DIAGNOSIS AND TEMPERATURE DISTRIBUTION MEASUREMENT SYSTEM BASED ON IMAGE PROCESSING TECHNIQUE ON 300MW UTILITY BOILER

Model-Based Water Wall Fault Detection and Diagnosis of FBC Boiler Using Strong Tracking Filter

Online reconstruction of 3D temperature field fused with POD-based reduced order approach and sparse sensor data

Multidimensional high-temperature field measurement method for flame based on near infrared radiation spectrum of water vapor

Monitoring of a Swirl Burner by a Flame Detector and Flame Image Information

Soft Sensor of Heating Extraction Steam Flow Rate Based on Frequency Complementary Information Fusion for CHP Plant