Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

A Novel Frequency Output Accelerometer Using Ring Oscillator and Mixer

Accelerometer Design Using MOS Ring Oscillator

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

The Modulation and Demodulation Module of a High Resolution MOEMS Accelerometer

A Ring Oscillator Pressure Sensor Using Mixer

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A New Type of MEMS Accelerometer with Up-Tuning Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A Novel Scheme Design of a High-G Optical NEMS Accelerometer Based on a Single Chip Grating with Proper Sensitivity and Large Bandwidth

A novel resonant accelerometer based on nanoelectromechanical oscillator

A Novel Accelerometer Based on Microring Resonator

A Novel Noise Resistance Optical Accelerometer Based on Micro-Ring Resonant Cavity

A novel out-of-plane MEMS tunneling accelerometer

A micromachined silicon resonant accelerometer

A Novel Micro-Machined Out-of-Plane Resonant Accelerometer with Differential Structure of Different-Height Resonant Beams

Silicon-Based Zipper Photonic Crystal Cavity Optomechanical System for Accelerometers

A novel sandwich capacitive accelerometer with a symmetrical structure fabricated from a D-SOI wafer

A resonnat accelerometer based on ring-down measurement

High-Performance Single-Side Fabricated (111)-Silicon Dual-Cantilever Accelerometer with Squeeze-Film Air Damping Modulation

A Mems Accelerometer Based On Synchronizing Detf Oscillators

A Novel Out-Of-Plane Mems Tunneling Accelerometer With Excellent Low Frequency Resolution