Abstract:International emission tests (EPA, SFTP, MVEG-B, J-10.15, etc.) are carried out with vehicles running on the rolls dynamometer. Results, in terms of total emissions, are influenced by vehicles parameters such as mass, gear ratios, front surface, drag coefficient, etc. It would be useful, in the automobiles design phase, to have information about the impact of these parameters on total emissions. The obvious solution would be to build up a complete vehicle model to simulate performance and emission levels. Engine pollutants production modeling is the weak point, since it is difficult to obtain reliable results. Anyway it is possible to avoid pollutants production simulation, testing the actual engine under the same operating condition it would face inside the car’s hood. This paper describes a methodology whose aim is to test the engine on a standard test bench, simulating on-board operating conditions. An equivalence condition has to be satisfied in order to guarantee the methodology effectiveness: engine speed and Manifold Absolute Pressure (MAP) must always match for the two types of test performed on the same driving cycle. Engine speed and torque can be controlled through the bench actuators, their values depending on the simulated vehicle motion: once the car dynamics are simulated by means of a model, engine speed and torque corresponding to the given driving cycle can in fact be evaluated. The model is solved in real time, its output being the brake load torque value satisfying the equivalence condition. The brake controller, used as a slave, regulates the engine operating conditions consequently. The global model incorporates tires, aerodynamic forces, clutch, gearbox and driveline behaviors simulation: its response has been first validated comparing its outputs with data measured on board, and then it has been used to control an eddy current brake, for vehicle test simulation on the test bench. Two different control philosophies can be used: either a human driver or an automatic controller can ride the simulated car. The influence of vehicle parameters and gearshift mode on fuel consumption and pollutant emissions can be investigated.

Inertia Matching During Dynamic Simulation of Vehicle Drive System on Test Bench

Design and Modeling of a Test Bench for Dual-Motor Electric Drive Tracked Vehicles Based on a Dynamic Load Emulation Method

Models of Two-Axle Driving Vehicle Used for Dynamometer Test Bench

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

An Automatic Testing System for Vehicle's Drive Axis Performance Test

Research on the Modeling, Control, and Calibration Technology of a Tracked Vehicle Load Simulation Test Bench

The Development of Dynamic Test Bench for EV Hybrid Brake System

Double-Drum Test Bench for Variable Load Transfer Simulation by Electromechanical Inertia Compensation

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

DESIGN OF A REAL-TIME DYNAMIC TEST BENCH FOR TESTING AND DEVELOPING A NOVEL SEAMLESS TWO-SPEED TRANSMISSION FOR ELECTRIC VEHICLES

Vehicle Simulation on the Test Bench

Engine-in-the-Loop in practical application: A sensitivity study toward the influence of test bench parameters

Electric Vehicle Tires Test Bench Design for Laboratory

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Analysis of Resistance Influencing Factors of a Bench System Based on a Self-Developed Four-Wheel Drive Motor Vehicle Chassis Dynamometer

Development of Compact Driver-in-the-Loop EMT Gearshift Test Bench

A Mechanical-Hardware-in-the-Loop Test Bench for Verification of Multimotor Drivetrain Systems

A Joint Simulation for Electric Vehicle Design based on MATLAB/Simulink and CarSim

Test Bench Emulation of Slip Ratio During Anti-Lock Braking of Electric Vehicle

Novel Control Algorithm for Dynamic Emulation of Mechanical Loads of the Three-motor Test Bench of the Electric Vehicle