Abstract:The electric wheel has an advantage of independently, accurately, and promptly controlling torque in response. However, current distributed drive steering control strategies fail to fully leverage this capability. To fill this gap, this paper proposes a composite electronic moment power steering (EMPS) control strategy for multi-axle distributed drive vehicles, based on dynamic modeling and analysis. The proposed control strategy integrates EMPS with direct yaw moment control (DYC), enhancing steering flexibility and fault tolerance in the steering system at low speeds, while also ensuring vehicle stability at high velocities. It adopts a hierarchical control architecture, wherein the upper controller utilizes a nonlinear state observer for the joint estimation of multi-objective parameters, and the lower controller is responsible for the accurate tracking of the steering angle by EMPS, the yaw rate tracking by DYC, and the assignment of weights to the composite controller. By establishing and analyzing a detailed vehicle model and an electric drive steering axle dynamics model, a multi-dimensional feasible domain for EMPS is proposed, ensuring the safety and smoothness of steering maneuvers. The co-simulation of MATLAB/Simulink and TruckSim are conducted to verify the effectiveness of the composite control strategy. The EMPS controller is proved to have robust steering angle tracking performance, with the β -β̇ trajectory consistently converging within the stability zone, maintaining a sufficient margin for tire longitudinal force under the composite steering control. Additionally, real vehicle testing confirms the effectiveness of EMPS and the redundancy tolerance of the steering functionality in distributed drive multi-axle vehicles equipped with EMPS.

Novel Control Algorithm for Dynamic Emulation of Mechanical Loads of the Three-motor Test Bench of the Electric Vehicle

Design and Modeling of a Test Bench for Dual-Motor Electric Drive Tracked Vehicles Based on a Dynamic Load Emulation Method

Eco-driving of Electric Vehicles with Integrated Motion and Battery Dynamics

Novel PI Control Algorithm for Dynamic Emulation of Mechanical Loads During Transmission Shift of Electric Vehicles

Dynamic Load Emulation of Slip Ratio Control in Anti-lock Braking of a Front-axle-drive Electric Vehicle

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

Dynamic load emulation for electric vehicle powertrain based on error tolerance control

Emergency Braking Control Strategy for High Speed Electric Drive Tracked Vehicle

Dynamometer controller algorithm for road load emulations

Dynamic Load Emulation of Regenerative Braking System during Electrified Vehicle Braking States Transition

Key Techniques Research for Physical Simulation of Dynamical Electric Loads Without Flux Linkage Observation

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Power Electronic Load System for Motor Drivers Testing Considering Motor Faulty Status Simulation

Hardware-in-the-loop Simulation of Electronic Differential Moment Power Steering Control Strategy for Multi-axle Vehicle

Study on Requirements for Load Emulation of the Vehicle With an Electric Braking System.

A Comprehensive Analysis on Electronic Moment Power Steering Control Strategy for Multi-axle Distributed Drive Vehicles

Simulation and Experiment of Distributed Drive Hybrid Multi-Axle Heavy-Duty Truck Dynamics Control Algorithm

Load Emulation of Track Vehicle on Test Bed

Experimental Platform for Evaluation of On-Board Real-Time Motion Controllers for Electric Vehicles

Test Bench Emulation of Slip Ratio During Anti-Lock Braking of Electric Vehicle

A Model Predictive Control Approach With Slip Ratio Estimation for Electric Motor Antilock Braking of Battery Electric Vehicle