Abstract:The complexity of automobile powertrains continues to increase, leading to increased development time and effort. One method to address this challenge is to shift vehicle calibration and testing tasks to simulations with Engine-in-the-Loop (EiL) test setups. This increases the efficiency of the development process through high flexibility, low prototype costs, an early starting point, and a high degree of automation. EiL emulates the dynamic interactions between the internal combustion engine and other powertrain components by closed-loop coupling to real-time simulation models. The coupling quality strongly depends on the interface properties, the hardware layout, and the control functionality of the dynamometer test bench. This paper analyzes an existing test bench and presents the impact of altered test bench parameters on different EiL quality aspects. Thereto, the setup is analyzed and a Simulink based grey box test bench model is derived. The latter is parametrized with a full factorial approach in comparison to real test bench measurements. The test bench model is then used for simulative investigations considering different test bench parameters: Two different use cases of Model-in-the-Loop (MiL) supported EiL are investigated. First, a simulative improvement of the test bench control quality by altering the PI based dyno speed controller parameters is investigated. The virtually calibrated controller parameters are applied to the real EiL system and compared to vehicle measurements. Second, sensitivity studies are shown with respect to dynamometer inertia and system dead time in terms of control quality and energy. As a major outcome, a compromise of control accuracy and stability for different speed controller parameters, dyno inertia, and system dead time is shown. Furthermore, it is demonstrated that EiL has only a small deviation in terms of energy compared to a full vehicle, making it a valid approach when considering CO 2 emissions.

Dynamic load emulation for electric vehicle powertrain based on error tolerance control

Design and Modeling of a Test Bench for Dual-Motor Electric Drive Tracked Vehicles Based on a Dynamic Load Emulation Method

Eco-driving of Electric Vehicles with Integrated Motion and Battery Dynamics

Novel Control Algorithm for Dynamic Emulation of Mechanical Loads of the Three-motor Test Bench of the Electric Vehicle

Dynamometer controller algorithm for road load emulations

Dynamic Load Emulation of Regenerative Braking System during Electrified Vehicle Braking States Transition

Development of Test-Bed Controller for Powertrain of HEV

Dynamic Load Emulation of Slip Ratio Control in Anti-lock Braking of a Front-axle-drive Electric Vehicle

Novel PI Control Algorithm for Dynamic Emulation of Mechanical Loads During Transmission Shift of Electric Vehicles

Study on Requirements for Load Emulation of the Vehicle With an Electric Braking System.

Key Techniques Research for Physical Simulation of Dynamical Electric Loads Without Flux Linkage Observation

Power Electronic Load System for Motor Drivers Testing Considering Motor Faulty Status Simulation

Load Emulation of Track Vehicle on Test Bed

Test Bench Emulation of Slip Ratio During Anti-Lock Braking of Electric Vehicle

Modeling and Integration of Electric Vehicle Regenerative and Friction Braking for Motor/Dynamometer Test Bench Emulation

Development of test-bed controller for hybrid electric vehicle based on dual-motor load system

Experimental Platform for Evaluation of On-Board Real-Time Motion Controllers for Electric Vehicles

Engine-in-the-Loop in practical application: A sensitivity study toward the influence of test bench parameters

Double-Drum Test Bench for Variable Load Transfer Simulation by Electromechanical Inertia Compensation

A Joint Simulation for Electric Vehicle Design based on MATLAB/Simulink and CarSim

Research on Electric Vehicle Powertrain Systems Based on Digital Twin Technology