Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

EXPERIMENTAL STUDY ON WIND ENERGY CONVERTING TO HEAT BY INCREASING FLUID PRESSURE AND FLOW THROTTLING

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Analysis of Flow Transition Effects on the Performances of a Wind Power Heat Pump System

Investigation on the Jet Impingement/Boiling Heat Transfer

Experimental Study of Kinetic to Thermal Energy Conversion with Fluid Agitation for a Wind-Powered Heat Generator

Experimental Study on Flow and Heat Transfer Performance of Condensing Gas-Fired Boiler

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER AND PRESSURE DROP FOR FIN-AND-TUBE HEAT EXCHANGERS WITH LARGE-ROW AND LARGE-DIAMETER TUBES

Experimental Study on the Tube-Side Thermal-Hydraulic Performance of Spiral Wound Heat Exchangers

Experimental Investigation On Heat Transfer And Frictional Characteristics Of Vertical Upward Rifled Tube In The Advanced Ultra Supercritical Steam Generator

Experimental and Numerical Investigation of Thermal -Hydraulic Performance in Wavy Fin-and-flat Tube Heat Exchangers

Experimental Study of the Condensation Heat Transfer Performance of Flue Gases in a Heating-and-power Cogeneration System

Experimental Study of the Flow and Heat Transfer of a Gas–water Mixture Through a Packed Channel

A New Method on Fluid-to-fluid Scaling for Heat Transfer in Tubes at Supercritical Pressures

An experimental study exploring heat transfer enhancement in tube in tube heat exchanger with pulsating flow

Forced Convection Heat Transfer Using High Temperature and Pressure Water in an Upward-Inclined Tube

Experimental investigation of flow visualization and thermal performance of flat-plate single-loop pulsating heat pipes

Investigation on the Heat Transfer Characteristics of the Steam-Water Two-Phase Flow in the Inclined Upward Smooth Tube in Sub-Critical and Near Critical Pressure Regions

Experiment on Forced Convection-Condensation Heat Transfer Characteristics Based on Finned Plate Configuration

Numerical Investigation on Heat and Mass Transfer of Slit Finned Tube Heat Exchanger with Humid Flue Gas

Thermo-hydraulic performance and exergy analysis of a fin-and-tube heat exchanger with sinusoidal wavy winglet type vortex generators

Study on Momentum Transfer Characterisitics of Variable Mass Flow in Collection Header of Utility Boiler