Performances and Combustion Characteristics of a Spark-Ignited Direct-Injection Flexible Fuel Engine

黄勇成,周龙保,刘圣华

DOI: https://doi.org/10.3321/j.issn:0253-987x.2003.07.007

2003-01-01

Abstract:Analyzed are the performances and combustion characteristics of a flexible fuel engine (FFE) with a new type of spark-ignited direct-injection circularly stratified-charge(DICSC) combustion system. This engine can operate on methanol, ethanol or gasoline. The results show that the FFE has the advantages of high thermal efficiency equivalent to that of direct injection diesel engine due to adopting the mixture stratification. NO_x emissions for alcohol and gasoline operation are only 10%—40% and 21%—78% of those of the diesel engine respectively at load characteristics. In the FFE,the CO emission is lower than 1%, and HC emission is slightly higher than that of the diesel engine. Smokeless combustion can be realized for alcohol operation at any operating conditions, and there exists little smoke emission for gasoline operation only at a high load. The calculated heat release rate of the FFE shows that the combustion process consists of premixing and diffusion stages and the combustion proceeds very stably and rapidly. Its cycle-to-cycle variation is lower than 6%. 50% of fuel burns out while the crank angle is situated at 3—5 degrees after top dead center, and the combustion duration is within 28—37 degrees crank angle. The combustion rate for methanol operation is higher than that for ethanol or gasoline operation. The combustion rate for gasoline operation is slightly higher at a low load and lower at a high load than that for ethanol operation.