Abstract:The introduction of solvent additives has become a general approach in optimizing the active layer morphology in organic photovoltaics (OPV) to achieve high power conversion efficiency. It is of general interest to understand the mechanism of how additives optimize the thin-film nanostructure formation such as crystallization kinetics and phase separation. In the current manuscript, state-of-the-art nonfullerene bulk heterojunction blends, PM6:IT-4F mixture, are used in a slot-die coating experiment. The 1,8-octanedithiol (DIO)-aided fabrication leads to a significant increase in the power conversion efficiency (PCE) from 10.11 to 12.67%. Exciton dissociation and carrier transport have also been improved, largely associated with morphology improvement. Time-resolved crystallization kinetics during PM6:IT-4F film formation under different processing conditions was studied by in situ grazing-incidence wide-angle X-ray scattering (GIWAXS), in which a detailed polymer fibril morphology formation was seen. The Johnson–Mehl–Avrami–Kolmogorov (JMAK) crystallization analysis affords insights that the addition of the DIO additive in a small amount would not only increase the nucleation rate during the nucleation and growth stage but also introduce secondary fibril crystal perfection via burst nucleation-mediated crystallization to a grain boundary-induced crystallization stage change. These observations can be of general interest to the OPV community in manipulating the printed solar cell morphology and efficiency toward the commercial application.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.macromol.0c02872?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.macromol.0c02872</a>.Photovoltaic parameters of slot-die-coated solar cells, additional TA spectra, GIWAXS patterns, AFM/TEM images, in situ GIWAXS data, and fitting results (<a class="ext-link" href="/doi/suppl/10.1021/acs.macromol.0c02872/suppl_file/ma0c02872_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Effect of Crystalline Microstructure on the Photophysical Performance of Polymer/Perylene Composite Films

Post-Fabrication Annealing Effects in Polymer-Nanotube Photovoltaic Cells

Quantitative Nanoscale Monitoring the Effect of Annealing Process on the Morphology and Optical Properties of Poly(3-Hexylthiophene)/[6,6]-phenyl C61-butyric Acid Methyl Ester Thin Film Used in Photovoltaic Devices

Study of the effect of annealing process on the performance of P3HT/PCBM photovoltaic devices using scanning-probe microscopy

Manipulating Crystallization Kinetics of Conjugated Polymers in Nonfullerene Photovoltaic Blends toward Refined Morphologies and Higher Performances

Correlating Nanoscale Morphology with Device Performance in Conventional and Inverted PffBT4T-20D:PC71 BM Polymer Solar Cells

Investigation of nanoscale morphological changes in organic photovoltaics during solvent vapor annealing

Correlating Nanoscale Morphology with Device Performance in Conventional and Inverted PffBT4T-2OD:PC<sub>71</sub>BM Polymer Solar Cells

Morphology manipulation for highly miscible photovoltaic blend of carboxylate-substituted polythiophene:Y6

Improvement of Surface Morphology of Thin ?lms and Performance by "electrical Annealing" on Polymer Solar Cells

Optimizing the Morphology of All-Polymer Solar Cells for Enhanced Photovoltaic Performance and Thermal Stability

Influence of thermal annealing on microstructure, energetic landscape and device performance of P3HT: PCBM-based organic solar cells

Unravelling the mechanism of processing protocols induced microstructure evolution on polymer thermoelectric performance

Characterizing the Morphology and Efficiency of Organic Solar Cells by Multiscale Simulations

Reduction in the Temperature Coefficient of Photovoltaic Efficiency in All-Polymer Solar Cells Using Molecular Order

Charge Separation And Transport In Organic/Inorganic Nanocomposites And Its Applications In Photovoltaic Devices

Electric Field-Assisted Self-Organization of Polymer:Fullerene Hybrids on the Photovoltaic Performance

Morphological Effect on Spectral Property of Poly(9,9-Dihexylfluorene-Alt-2,5-Dihexyloxybenzene) Films

Annealing Of P3ht:Pcbm Blend Film-The Effect On Its Optical Properties

Effects Of Thermal Annealing On Photoluminescence Spectra In Pi-Conjugated Polymer Film: Evidence For Dual Emission By Temperature Dependent Measurements

Design, Application, and Morphology Study of a New Photovoltaic Polymer with Strong Aggregation in Solution State