Abstract:The Lebowitz solution of the Percus-Yevick hard-sphere mixture is invoked with the square-well potential function to determine Ashcroft-Langreth type three partial correlation functions in binary Cu-In liquid alloys. These computed partial correlation functions have been employed to generate Bhatia-Thornton fluctuations in the considered melts. Using these structural parameters we investigate the temperature and composition-dependent diffusion coefficients of considered melts. The computed values of concentration-concentration fluctuations, in the long-wavelength limit and the Warren-Cowley short-range order parameter, show the formation of chemical compounds between unlike atoms in the In-rich region of Cu-In melts. We find a very good agreement between theoretically formulated and computed data of with the corresponding experimental values. Computed results of and suggest that hetero coordination is favorable over homo coordination in the investigated melts. The validity of the Stokes-Einstein relation was observed over a wide range of temperature and composition in the investigated melts. Further, a new correlation between two body pair excess entropy and the Stoke-Einstein relation has been formulated for square-well binary liquid alloys. Surface tension and compressibility as a function of In composition have been computed through microscopic structural functions of the alloys. Computed , , surface tension and ratio of mutual to intrinsic diffusion (Dm/Did) are found comparable to available simulated data. The computed values of shear viscosity are in good agreement with the experimental data. Calculated results suggest that the combination of hard sphere potential with square-well tail under mean spherical model approximation is one of the good method for determining the structures and transport coefficients of compound forming binary liquid alloys.

Correlation Between Local Clusters and Structure of Al71cu29 Melt

Experimental Andab Initiomolecular Dynamics Simulation Studies of Liquidal60cu40alloy

Structural Studies of Clusters in Melt of FeAl Compound

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

Molecular Dynamics Study of Stability of Solid Solutions and Amorphous Phase in the Cu-Al System

The Structure Determination of Al20Cu2Mn3 by Near Atomic Resolution Chemical Mapping

The Microstructure in an Al–Ti Alloy Melt: The Wulff Cluster Model from a Partial Structure Factor

Impact of local structure on melt dynamics in Cu-Ti alloys: Insights from ab-initio molecular dynamics simulations

Cluster Structure And Dynamics Of Liquid Aluminum Under Cooling Conditions

Correlation Between Structure and Mechanical Properties of Amorphous Cu–Ag Alloys

Correlation between structures and atomic transport properties of compound forming liquid Cu-In alloys

Local Structures of Mechanical Alloying Fe70Cu30 System Studied by XAFS

Structural And Dynamical Properties Of Liquid Cu80si20 Alloy Studied Experimentally And By Ab Initio Molecular Dynamics Simulations

Evolution of local atomic structure during solidification of Al 2Au liquid: An ab initio study

Electronic-Structure Effect on Model Cluster for L1(2) Structure of Al3ti Intermetallic Compound with an Addition of Alloying Elements Fe, Ni and Cu

Correlation between the topologically close-packed structure and the deformation behavior of metallic Cu 64.5 Zr 35.5

Evolution of Atomic Structure in Al75cu25 Liquid from Experimental and Ab Initio Molecular Dynamics Simulation Studies

Structure and Property of Metal Melt Ii-Evolution of Atomic Clusters in the Not High Temperature Range above Liquidus

3D local atomic structure evolution in a solidifying Al-0.4Sc dilute alloy melt revealed in operando by synchrotron X-ray total scattering and modelling

Correlation between medium-range order structure and glass-forming ability for Al-based metallic glasses

Local Structure Order in Pd78Cu6Si16 Liquid