Abstract:The addition of Mn to 7xxx series Al-alloys helps improve tensile properties owed to the presence of α precipitates (Al(Mn,Fe)Si, simple cubic, 50-200 nm, non-shearable) in addition to the η' precipitates ( Mg2Zn5−xAl2+x , hexagonal, 4-6 nm, shearable) commonly observed in the 7xxx series Al-alloys. The coexistence of multiple α and η' variants, 24 for α and 4 for η', coupled with their small size-scale, makes the experimental determination by x-ray diffraction (XRD) and scanning transmission electron microscopy (STEM) challenging. This work formulates a phase-field model to predict precipitate shapes in three-dimension (3D) using experimental characterization as inputs to create virtual precipitate cross-sections for use in morphological comparison with experimental 2D (S)TEM images. Based on the atomic structures and orientation relationships observed in the experiments, the lattice site correspondences between the matrix and the two precipitate phases are derived, which are required for the prediction of shapes of coherent precipitates. Systematic phase-field simulations are then carried out to document the 3D shapes for all possible variants, as well as the corresponding 2D cross-sectional shapes when observed parallel to low-index matrix planes. These 2D cross-sectional shapes are compared with high-angle annular dark-field STEM (HAADF-STEM) images, which demonstrates that the identification of Mn precipitate type is possible by such comparisons. This helps unravel some of the complications encountered when characterizing precipitate microstructures in Mn containing Al-alloys by STEM. Finally, the equilibrium shapes as a function of precipitate size and the effect of interfacial energy anisotropy are investigated.

The Structure Determination of Al20Cu2Mn3 by Near Atomic Resolution Chemical Mapping

Atomic-scale Chemical Imaging and Quantification of Metallic Alloy Structures by Energy-Dispersive X-ray Spectroscopy

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

The Disordered Structure of Q′ and C Phases in Al–Mg–Si–Cu Alloy

Investigation on structural stability of as-cast Al0.5CrCuFeMnTi high entropy alloy

Formation enthalpies of Al-Mn-Pd and the structure of the $i$-AlMnPd quasicrystal

From Phason Planes to Superstructures in an Al–Pd–Mn Alloy

Thermodynamic calculation of high zinc-containing Al-Zn-Mg-Cu alloy

First-principles study of crystal structure and stability of T1 precipitates in Al-Li-Cu alloys

A combined simulation and experimental study of the equilibrium shapes of η' and α precipitates in Mn-containing 7xxx Al-alloys

First-Principles Study of the Structural, Mechanical, Electronic, and Thermodynamic Properties of AlCu2M (M = Ti, Cr, Zr, Sc, Hf, Mn, Pa, Lu, Pm) Ternary Intermetallic Compounds

Structure Model with M35 Symmetry and 12 Coordinates

The Local Structure of Molten Ni 1−x Al X : an Ab Initio Molecular Dynamics Study

Modeling the amorphous structure of a mechanically alloyed Ti50Ni25Cu25 alloy using anomalous wide-angle x-ray scattering and reverse Monte Carlo simulations

Structures of melt-spun and high-energy ball milled Al3Ti-Mn-Nb intermetallic alloy

Influence of Mg Doping on the Structure and Mechanical Properties of Al2Cu Precipitated Phase by First-Principles Calculations

Phase equilibria, crystal structure of δ1-MnZn9 and thermodynamic re-assessment of the Zn-Mn system

Mechanical Properties and Work Function of L21 Structure AlCu2X (X = Ti, Mn, Zr, or Hf) Intermetallics

Study of α′′-phase Fe16X2−nYn (X,Y = N, C) alloys by molecular dynamics modeling

Clustering Characteristics of Fe-rich Intermetallics in High Vacuum Die Cast AlSiMgMn Alloys with High Resolution Μ-Ct Inspection

Exafs Measurements and Reverse Monte Carlo Modeling of Atomic Structure in Amorphous Ni80p20 Alloys