Abstract:High current pulsed electron beam (HCPEB) is now developing as a useful tool for surface modification of materials. When concentrated electron flux transferring its energy into a very thin surface layer within a short pulse time, superfast processes such as heating, melting, evaporation and consequent solidification, as well as dynamic stress induced may impart the surface layer with improved physico-chemical and mechanical properties. This paper presents our research work on surface modification of steels and magnesium alloy with HCPEB of working parameters as electron energy 27keV, pulse duration ∼1μs and energy density ∼2.2J/cm2 per pulse. Investigations performed on carbon steel T8, mold steel D2 and magnesium alloy AZ91HP have shown that the most pronounced changes of phase–structure state and properties occurring in the near-surface layers, while the thickness of the modified layer with improved microhardness (several hundreds of micrometers) is significantly greater than that of the heat-affected zone. The formation mechanisms of surface cratering and non-stationary hardening effect in depth are discussed based on the elucidation of non-equilibrium temperature filed and different kinds of stresses formed during pulsed electron beam melting treatment. After the pulsed electron beam treatments, samples show significant improvements in measurements of wear and corrosion resistance.

Rapid surface alloying of steels by Al using high current pulsed electron beam and oxidation resistance

Oxidation protection of AISI H13 steel by high current pulsed electron beam treatment

Surface Modification of H13 Steel by Arc Deposition of Al Film and High Current Pulsed Electron Bombardment

Oxidation resistance of a hot-die steel (H13) with Al coating and high current pulse electron beam treatment

Surface Modification of Aluminized Cu-10fe Alloy by High Current Pulsed Electron Beam

Surface Modifications of a Cold Rolled 2024 Al Alloy by High Current Pulsed Electron Beams

Surface Modification of Steels and Magnesium Alloy by High Current Pulsed Electron Beam

A Study on the Die Steel Surface Modification by Electron Beam

Surface Modification by High Current Pulsed Electron Beam

Surface Treatment of Materials with High Current Pulsed Electron Beam

Microstructure and Properties of Mechanical Alloying Al-Zr Coating by High Current Pulsed Electron Beam Irradiation

Microstructure and Properties of Ti Alloying Surface on 9310 Carburizing Steel by High Current Pulsed Electron Beam

Surface Modifications of a Hyperperitectic Zn-10 Wt% Cu Alloy by Pulsed Electron Beam Treatment

Grain refinement, hardening and metastable phase formation by high current pulsed electron beam (HCPEB) treatment under heating and melting modes

Grain Refinement and Improved Hardness/Corrosion Balance by Pulsed Electron Beam Surface Treatment of a FeAl Alloy

Effect of High Current Pulsed Electron Beam Treatment on Surface Microstructure and Wear and Corrosion Resistance of an AZ91HP Magnesium Alloy

Enhancing Corrosion Resistance of AISI 316L Steel Surface Alloyed with Ti by High Current Pulsed Electron Beam

Analysis of Metals Surface Structure Modifications Induced by High Current Pulsed Electron Beam (HCPEB) under the “heating” and “melting” Modes

Microstructure and property modifications in surface layers of a Mg-4Sm-2Al-0.5Mn alloy induced by pulsed electron beam treatments

Microstructure and property modifications in a near α Ti alloy induced by pulsed electron beam surface treatment

Ti Surface Alloying of an Aisi 316l Stainless Steel by Low Energy High Current Pulsed Electron Beam Treatment