Abstract:An elasto-plastic contact model of M50 steel sliding-rolling friction pair was built by using the finite element method.Under the high-speed and heavy-load condition that the contact stress was about 4.0 GPa and the velocity was about 50 m·s-1, the Von Mises stress, shear stress and plastic deformation of surface layer were analyzed, the effects of the friction coefficient and the relative sliding velocity on the contact behaviors of the M50 steel sliding-rolling friction pair were studied, and the plastic deformations of surface layers were compared in M50 steel double-roller sliding-rolling test result.Calculation result shows that the differences of maximum contact stresses and major and minor axis lengths of elliptical contact region between the finite element analysis result and the Hertz theory calculation result are 2.66%, 0.26% and 6.43%, respectively.When the friction coefficient increases from 0.1 to 0.5, the location of maximum Von Mises stress gradually moves from the friction pair subsurface at about 0.5 mm to the contact surface.When the scuffing failure of friction pair surface occurs, the friction coefficient is more than 0.3, and the maximum Von Mises stress is over 1 700 MPa.When the scuffing failure occurs, the stress and plastic strain of M50 steel friction pair have specific direction.Under the condition that sliding-rolling ratios are 0.12 and 0.15, respectively, the maximum Von Mises stresses are 2 847 MPa and 2 689 MPa on the contact point with higher linear velocity, which leads to relatively large plastic strain, and the maximum values are 0.062 and 0.061, respectively.However, on the surface with lower linear velocity at the two sliding-rolling ratios, the maximum Von Mises stresses are 2 269 MPa and 2 101 MPa, respectively, the plastic strains are smaller, and the maximum values are 0.040 and 0.039, respectively.3 tabs, 11 figs, 25 refs.

Elastoplastic Model with Boundary Lubrication of Rolling Press Analysis for Skin Pass

COMPARISION OF PREDICTION MO DELS FOR SKIN ROLLING FORCE

Surface texture transfer in skin-pass rolling with the effect of roll surface wear

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Analysis and prediction of maximum contact stress and depth by ultrasonic surface rolling with elastic–plastic theory

Coulomb, Tresca and Coulomb-Tresca Friction Models Used in Analytical Analysis for Rolling Process of External Spline

Analysis of Rolling Force Model in Cold Rolling Mill

Prediction of Surface Wrinkle Defect of Welding Wire Steel ER70S-6 in Hot Bar Rolling Process Using Finite Element Method and Experiments

Analysis of the Vertical Stiffness of Rolling Guide That Involves the Elastic Deformation of Carriage Skirt

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

Research onForecast of Roll Wear of PC Mill

Elastic-plastic Analysis of Stainless Steel Spherical Shell Punch Press Forming CAM System

A Study of Tribological Performance Prediction Based on Surface Texture Parameters

An Elastoplastic Contact Model Considering Wear Based on Digital Rough Surfaces in Spatial Domain

Numerical Thermal Analysis of Greased Rolling Bearing Considering Surface Topography and Plastic Deformation

The Analysis of Elastohydrodynamic Lubrication in the Textured Journal Bearing

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

Mechanics characteristics of surface damage on sliding-rolling friction pair under high-speed and heavy-load condition

Simulation of the rolling process of 4-high hot steel strip continuous mills