Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

COMPARISION OF PREDICTION MO DELS FOR SKIN ROLLING FORCE

Elastoplastic Model with Boundary Lubrication of Rolling Press Analysis for Skin Pass

Prediction of Sliding Friction Force of Rough Surfaces in Lubricated Point Contacts

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

A method for predicting critical load evaluating adhesion of coatings in scratch testing

Research of the Indirect Friction Sensor for Prediction of Contact Stress by Improved Inverse Method in Strip Rolling

Surface texture transfer in skin-pass rolling with the effect of roll surface wear

Analysis of Rolling Force Model in Cold Rolling Mill

Numerical Simulation of Elastic Deformation of Roller Based on Thermo-Mechanical Coupling

Research onForecast of Roll Wear of PC Mill

Analysis of rolling force and layer thickness in bimetal clad rolling

Study on the Prediction of Rolling Force of 16mnr Hot Rolled Plate

A fast calculation method of large-cylinder asymmetrical rolling force considering shear effect

Analysis of the Vertical Stiffness of Rolling Guide That Involves the Elastic Deformation of Carriage Skirt

A New Prediction Method for the Preload Drag Force of Linear Motion Rolling Bearing

The Fem Analysis Of Rolling-Sliding Contact Under Boundary Lubrication'S

Analysis and prediction of maximum contact stress and depth by ultrasonic surface rolling with elastic–plastic theory

Analytical prediction of roll coating with counter-rotating deformable rolls

Adaptive learning prediction on rolling force in the process of reversible cold rolling mill

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters