Abstract:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, Ahead of Print. Heavy-duty gas turbines represent a highly efficient method for converting heat into power within power generation systems. As the technology behind these turbines advances, their operational efficiency and stability have become paramount. The intake volute, a crucial component of the turbine's intake system, significantly affects the airflow dynamics within the inlet channel of the pressurized turbine. This study employs numerical simulations to analyze the airflow field within the L inlet volute duct of a heavy-duty gas turbine. Initial findings indicate a lack of uniformity in the airflow field as it transitions through the volute's turning section into the contraction area. Modifications to the arc structure at the airflow corners have demonstrated potential for enhancing flow uniformity in the constriction section while reducing total pressure distortion at the volute duct's outlet. Further analysis of linear structural parameters of the contraction section, including the taper angle (α) and the tilt angle (β) at the rear of the inlet chamber, reveals that a lower Bezier curve parameter I significantly diminishes exit airflow distortion. Conversely, Bezier curve parameter II appears to exert minimal influence on airflow distortion. Optimal taper and tilt angles, ranging from 25° to 30° and 9° respectively, minimize mean velocity inhomogeneity and total pressure distortion at the outlet. Compared to the original structure, these adjustments reduce mean velocity inhomogeneity by 55.19% and total pressure distortion by 53.93% at the duct's outlet, thus achieving a more uniform flow field.

Effect of the Structure Parameters of Helical Intake Duct on the Flow Field in Diesel

Influence of Intake-port Layout on Air Flow around Intake-valve of a Two-valve Diesel Engine

Numerical Simulation of Effects of Venturi Tube Throat Diameter on Flow Field of Combustor

Fluid flow in rotating helical square ducts

One-Dimensional Gas Flow Analysis of the Intake and Exhaust System of a Single Cylinder Diesel Engine

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Three-Dimensional Simulation for Helical Intake Port of 4BTAA Diesel Engine

Influence of Inlet Duct Length on the Hydraulic Performance of the Waterjet Propulsion Device

Experimental and Numerical Investigation of the Non-Reacting Flow in a High-Fidelity Heavy-Duty Gas Turbine DLN Combustor

Experimental and numerical investigations into flow features in an intake duct for the waterjet propulsion under mooring conditions

Comparisonstudies on flow measurement methods for cylinder water hole in diesel engine

Numerical research on the aerodynamic performance of inlet volute duct for a heavy-duty gas turbine

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Research on Flowability in Intake Port of Turbocharged Diesel Engine at High Port Pressure Drop

Numerical study on aerodynamic performance of an intake duct affected by ground effect

DESIGN OF INTAKE MANIFOLD AND EXPERIMENTAL STUDY FOR PRESSURE WAVE SUPERCHARGED DIESEL ENGINES

Effects of different parameters on the flow field of peripheral ported rotary engines

Modification Design of Inlet Duct for a Helium Circulator

Optimization of Gasoline Engine Intake System Based on 1D, 3D and Coupled Simulations

Three-dimensional Simulation and Optimization of Engine Intake Ports

An Experimental Study on Intake-ports Characteristics of a Four-valve Diesel Engine