Abstract:This paper outlines a method which links the following analytically simulated events in sequence: (1) braiding of a 3D preform of tubular cross-section—characterized by a set of braiding parameters defining the braiding setup and braiding steps; (2) geometric description of the yarn topology in the braided preform—in explicit terms of a set of topological parameters defined by the preform shape and the braiding parameters; (3) description of the exact yarn distribution after preform consolidation with a binding matrix—the values of the topological parameters are related to the exterior dimensions and surface features of the consolidated preform; and (4) forecasting the mechanical properties in the final composite—via a suitable micromechanics model that takes into account the spatial yarn distribution in the composite and properties of the constituents.It is shown that these sequential events form a closed-loop linkage which connects the properties of the final composite all the way to the initial preform braiding setup design; the analytically derived interrelationships in each link can provide for design simulations of three dimensionally braided, complex-shaped and property-specific composite articles.In order to obtain explicit interrelationships, the 4-step 1×1 braiding procedure is utilized in the analytical development. For the same reason, a graphite yarn and an epoxy resin with known properties are used in illustrative examples. There can be more than one braiding setup design for a preform to have the same shape and overall dimensions; but the yarn structure and properties in the final composite can differ widely if different braiding setups are used. Hence an optimization for a composite shape to meet the prescribed requirements may be conducted using the developed closed-loop.

Microstructure Analysis of 4-Step Three-Dimensional Braided Composite

Micro-CT Characterization on the Meso-Structure of Three-Dimensional Full Five-Directional Braided Composite

A STRUCTURAL ANALYSIS OF THREE-DIMENSIONAL BRAIDS

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Evaluation of elastic properties of 3D 4-directional braided composites

Unit-cell geometry and mechanical properties of three-dimensional seven-directional braided composites

X-ray microtomography analysis of the damage mechanisms in 3D circular braided carbon fiber/epoxy resin composite tubes under axial impact compression

Structural mechanics of 3-D braided preforms for composites. IV - The 4-step tubular braiding

Design Method for Braiding Process and Structure Parameters of Three Dimensional Two-Step Tubular Braided Preform

Parametric characteristics analysis of three cells in 3D and five-directional annular braided composites

A New Unit Cell Concerned Realistic Geometry Structure of 3D Four Directional Braided Composite

Meso-scopic Computing Mechanics Analysis of Three-Dimensional Multi-Directional Braided Composites

Investigation of parameterized braiding parameters and loading directions on compressive behavior and failure mechanism of 3D four-directional braided composites

On the topological yarn structure of 3-D rectangular and tubular braided preforms

Numerical investigation of tensile behavior of three-dimensional six-directional braided composites

Mesoscale progressive damage and strength analysis of three-dimensional braided composites under tension

Point-Based Mesoscopic Modeling and Simulation for Two-Step 3D Braided Composites

Experimental study on the fabrication, high-temperature properties and failure analysis of 3D seven-directional braided composites under compression

Study on in-plane compression properties and numerical modeling of three dimensional five-directional braided composites

A Methodology to Obtain the Accurate RVEs by a Multiscale Numerical Simulation of the 3D Braiding Process