Abstract:Pilot tests were carried out on a I MW thermal pulverized coal fired testing furnace. Symmetrical combustion was implemented by use of two whirl burners with dual air adjustment. The burnout air device was installed in various places at the top of the main burner, which consists of a primary air pipe with a varying cross-section and an impact ring. In the primary air pipe, the air pulverized coal (PC) stream was separated into a whirling stream that was thick inside and thin outside, thus realizing the thin-thick distribution at the burner nozzle in the radial direction. From the comparative combustion tests of three coals with relatively great characteristic differences, Shaanbei Shenhua high rank bituminous coal (SH coal), Shanxi Hejin low rank bituminous coal (HJ coal), and Shanxi Changzhi meager coal (CZ coal), were obtained such test results as the primary air ratio, inner secondary air ratio, Outer secondary air ratio, impact of the change of outer secondary air, change of the relative position for the layout of burnout air, change of the swirling intensity of the primary air and secondary air, etc., on the NOx emission, and unburnt carbon content in fly ash (C-FA). At the same time, the relationship between the NOx emission and burnout ratio and affecting factors of the corresponding test items oil the combustion stability and economic results were also acquired. The results may provide a vital guiding significance to engineering designs and practical applications. According to the experimental results. the influence of each individual parameter oil NOx formation and unburned carbon in fly ash agrees well with the existing literature. In this study, the influences of various combinations of these parameters are also examined, thus providing some reference for the design of the radial biased swirl burner, the configuration of the furnace, and the distribution of the air.

A SIMULATION STUDY ON THE SEPARATING PERFORMANCE OF AN IMPACT TYPE FUEL RICH-LEAN BURNER AFFECTED BY THE ELBOWS

Simulation Study on Composite Structure of Impact Type Fuel Rich-lean Burner and Elbows

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

STUDY ON SEPARATION AND RESISTANCE PROPERTIES OF VENTURI RICH/ LEAN PULVERIZED COAL BURNERS

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

Numerical Simulation on the Rich/Lean Pulverized Coal Burner

Research on Separation Characteristics and Resistance Characteristics of Two-Phase Flow in Rich Lean Burner

THE DIFFUSION CHARACTERISTICS OF THE HORIZONTAL FUEL RICH-LEAN GAS-SOLID BURNER FLOW

Effect of elbow structure on gas-so lid separation and flow field adjacent to the exit of the swirl burner

THE NUMERICAL INVESTIGATION ON THE TRANSIENT CHARACTERISTICS OF THE GAS-SOLID TWO-PHASE FUEL RICH-LEAN BURNER FLOW

DEM–CFD Simulation of the Particle Dispersion in a Gas–solid Two-Phase Flow for a Fuel-Rich/lean Burner

Flamelet LES of a Swirl-Stabilized Multi-Stream Pulverized Coal Burner in Air and Oxy-Fuel Atmospheres with Pollutant Formation

Numerical Simulation for Gas-solid Two-phase Flow in New Type Rich-lean Steady Burner

The Effect of Primary Air Duct Elbow on Gas-Solid Flow of Swirling Burner Outlet

Experimental investigations on performance of collision-block-type fuel-rich/lean burner: Influence of solid concentration

Numerical Simulating for the Swirling Jet Two-Phase Flow from Pulverized Coal Rich/Lean Burner

EXPERIMENTAL AND NUMERICAL STUDY ON THE IMPROVEMENT OF THE VANES OF THE HORIZONTAL BIAS BURNER

B203 NUMERICAL INVESTIGATION OF FUEL CHARACTERISTICS AND CONCENTRATION ON PULVERIZED COAL COMBUSTION(Combustion-4)

Experimental Study on Nox Emission and Unburnt Carbon of A Radial Biased Swirl Burner for Coal Combustion

Experimental investigation on effect of over fire air equipping on a swirling burner on NOx emission and burnout ratio

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler