Abstract:The hot deformation behavior of a new heat resistant steel G115 designed for 650 °C ultra-supercritical (USC) power plants was experimentaly studied. Hot compression test was carried out in the temperature range of 900−1200°C and the strain rate range of 0.1–20 s−1 by using Gleeble-3800 thermal-mechanical simulator, and the corresponding flow curves were obtained. Experimental results show that the flow stress increases with the decrease of deformation temperature and the increase of strain rate. The hot deformation activation energy of G115 steel was determined to be 494 kJ/mol and the constitutive equation was also obtained. For convenience of the practical application, a good approximate equation was obtained for calculating the peak stress values of G115 steel under different deformation conditions. At the strain value of 0.9, natural logarithm of the critical Zener-Holomon parameter Zc of G115 steel was determined to be in the scope of 0.9, natature and 50.65, above which there wil be no dynamic recrystaliza-tion (DRX). And natural logarithm of the critical Zener-Holomon parameter Zs of G115 steel was determined to be in the scopes of 45.58 and 46.27, below which ful DRX may occur. Then, the status diagram of dynamic micro-structures of G115 steel was established. In addition, the strain rate sensitivity of G115 steel is not constant during the test temperature range and it increases linearly from 900 to 1200 °C. Therefore, hot deformation at higher temperatures would obtain beter workability.

Development and Application of High Chromium Heat-Resistant Steel

Development Retrospect and Composition Design of Typical Heat Resistant Cr-Mo Ferritic Steels for Boiler and Vessel

An overview on the novel heat-resistant ferritic stainless steels

Alloy Design and Development of High Cr Containing FeCrAl Ferritic Alloys for Extreme Environments

Research Progress on High-temperature Oxidation of Austenitic Stainless Steel for Ultra-superCritical Boilers

Present Research Situation And Prospect Of Hot Working Of Cast & Wrought Superalloys For Aero-Engine Turbine Disk In China

Field Studies of Steam Oxidation Behavior of Austenitic Heat-Resistant Steel 10Cr18ni9cu3nbn

Hot Deformation Behavior of A New 9%cr Heat Resistant Steel G115

Research Progress on Intergranular Corrosion Resistance of Super304H Austenite Stainless Steel

New Research Development of Superalloy GH4169

Research Progress of Austenitic Heat Resistant Steel Sanicro25 Used in Ultra Supercritical Unit

High-temperature oxidation behavior and subsurface phase transformation of high-Mn high-Al steel

Development Situation of the Overseas Titanium Alloys Used for Aircraft Engine

Study on the Corrosive Resistance of New High Chromium Alloy and NiCrFe-Cr3C2 Arc-Sprayed Coating in High-Temperature

Research Progress on High-Temperature Microstructure and Property Evolution of Super304H Austenitic Stainless Steel

Study on high-temperature creep behavior of nickel-base single crystal supper alloy

Brief discussion on Heat-resisting Steel for Ultra-supercritical Boiler

Research Progress of HR3C Heat Resistant Steel Used in Ultra Supercritical Boiler

Research Progress of Wrought Superalloys in China

Structural Changes of 12cr1movg Steel During High-Temperature Creep

Study on Intelligent Classification of Aging Heat-Resistant Materials