Abstract:The engineering realm confronts formidable challenges in combating the persistent issue of high-temperature oxidation in ultra-supercritical coal-fired boiler tubes. This study is dedicated to tackling these challenges by employing high-velocity oxy-fuel spraying (HVOF) and high-frequency induction remelting techniques. Our primary objective is to establish a metallurgical bond between self-fusing FeCoNiCrMo high-entropy alloy (HEA) powder and the conventional 15CrMo boiler steel tube surfaces, all within ambient atmospheric conditions. Our investigation reveals two distinct stages of oxidation for the HEA coating when exposed to a 900 °C air environment. Initially, there is a rapid oxidation stage driven by interfacial reactions, followed by a steady-state slow oxidation stage influenced by ion diffusion. The presence of a dense Cr 2 O 3 layer plays a pivotal role in reducing the oxidation rate significantly, thereby imparting exceptional high-temperature oxidation resistance to the FeCoNiCrMo HEA coating. Notably, during the steady-state stage, the oxidation rate is two orders of magnitude lower than observed in Ni-based superalloys. Minimal phase transformations or transitional layers at the interface underscore superb interface bonding at 900 °C. These findings provide a promising avenue for the cost-effective fabrication of highly oxidation-resistant ultra-supercritical boiler tubes. This advancement contributes significantly to the progress of engineering applications.

Microstructural Evolution and Oxidation Resistance of T92 Boiler Tube Steel Upon Long-Term Supercritical Steam Test

Steam oxidation behavior of T92 steel tube for high temperature reheater after long-term service in ultra-supercritical boilers

Failure behavior analysis of oxide film formed on super-heater tubes of boiler during deep peak process

Oxidation Behaviors of Different Grades of Ferritic Heat Resistant Steels in High-Temperature Steam and Flue Gas Environments

High-temperature corrosion data and mechanisms for T122, Super304H and HR3C after 15 years in 1000MW ultra-supercritical power plant

Micro characteristics and macro performance of HR3C/T92 steel joints after 100000 hours service at high temperature

Microstructure understanding of high Cr-Ni austenitic steel corrosion in high-temperature steam

Research on Remaining Life Evaluation Method of T92 Steel for Superheater Tube Based on Oxide Layer Growth

Type IV cracking of P92 steel welded joint used in China power plants

Microstructure Evolution and Failure Mechanism of Cr-coated Zry-4 in Air and Steam at 1200 °C

High-Temperature Degradation and Protection of Ferritic and Austenitic Steels in Steam Generators

Structural and Mechanical Characterization of Service Exposed 2.25Cr–1Mo Steel

Analysis on the microstructure and properties of P92 steel after long-term service at high temperature

Materials for ultra-supercritical coal-fired power plant boilers

High Temperature Oxidation of Superalloys in Steam Environment

Addressing challenges in high-temperature oxidation of ultra-supercritical boiler tubes via FeCoNiCrMo high-entropy alloy coatings

Effect of on-site service for 16,000 and 38,000 h on microstructure and mechanical properties of austenitic steel HR3C reheater tubes

The Process of Steam Oxidation Degradation of High Cr Steel after 125 000 Hours at 568 °C under 16.5 MPa

Microstructure-Property Relationship and Embrittlement Mechanism of HR3C Steel with High-Temperature Service of 65000 h

Microstructural Evolution of P92 Steel with Different Creep Life Consumptions After Long-Term Service