Numerical Analysis of GTAW Arc Behaviors in External Axial Magnetic Field
Xianqing Yin,Yuanyi Wu,Jianxun Zhang,Ninshu Ma,Jian‐Jun Gou
2012-01-01
Abstract:In welding process, it is widely accepted that grain refinement is an effective way to improve the properties of welding joints. When fine equiaxed grain was formed in the microstructure of welding joints, the tendency of welding crack would be decreased, and mechanical properties would be improved [1] . In seeing this, both metallurgical methods, by adding alloying elements in the welding pool, and mechanical methods, by mechanically stirring or vibrating the welding pool, have been broadly investigated to refine grains. In practice, a lot of methods, such as mechanical vibration [2-3] , ultrasonic vibration [4-5] , pulse current [6-7] , electromagnetic stirring, has been implemented to stir or vibrate the welding pool and thus refine the grains. During all of such mechanical methods, electromagnetic stirring distinguished itself by its lower investment and applicability. Generally, research on electromagnetic stirring welding concentrates on three aspects listed as arc behaviors, analysis of microstructure & properties, and model of welding arc & pool. In all of three concerns mentioned above, arc behaviors are so general and basic for understanding the mechanism of electromagnetic stirring, because arc behaviors are responsible for the heat transfer, heat distribution, penetration and vibration of weld pool. So, research on arc behaviors should be stressed and given a priority. Many researchers have done a lot of work about welding arc and acquired many great achievements [8-14] , even though it is a very long and hard journey. In present paper, MHD equations are built in order to describe the GTAW arc behavior at external constant axial magnetic field. With the help of CFD software FLUENT, the GTAW arc behaviors are studied and discussed. The arc pressure is measured and the results are used to validate the model. 2. Experimental system Fig.1 shows the experimental system used in this work. We made an exciting coil, and a DC power provides the exciting current, and then the coil generates the axial magnetic field. The arc pressure is investigated by the data collecting card and the pressure sensor which is connected with the hole in the center of the water-cooled copper.