Abstract:In this study, a high valued product submicronic ?-alumina was successfully extracted from aluminum slags generated by the local aluminum industry. The extraction technique was based on the leaching of slags by H2SO4 followed by precipitation. The coarser aluminum-rich fractions of the slags were used in this study instead of the finer oxide-rich fractions that were commonly used in previous studies. The precipitation of the leached slags by NH4OH was controlled by a zetameter in order to determine the optimal precipitation pH. Then, the obtained gel showing the higher precipitation rate and the finer particle size was calcined at 1200 ?C and characterized by the XRF, XRD, FTIR, SEM, EDS, and laser granulometry. Even without any pretreatment of slags, the XRF analysis revealed that a high purity and high extraction efficiency of 99.2% and 93.75% respectively could be achieved just at a leaching acid concentration of 15%. The XRD spectrum shows that the produced alumina was pure a-corundum, which was confirmed by the FTIR spectrum showing only the Al-O bonds. The laser granulometry showed that the recovered powder exhibited a wide particle size distribution, which was between 50 nm and 20 ?m, while the average particle size (d50) was about 400 nm. The SEM observations revealed that the grains were in the form of submicronic whiskers. The above characteristics allowed the obtained alumina powder in this study to be used in the usual applications of alumina such as refractory, ceramic fibers, abrasive, etc. The obtained powders may also assume applications as a thermally stable substitute for the commonly used transition alumina powders, which needs further investigations in future studies.

The applications of pyro-liquidized synthetic alumina in electrical engineering and special glass industries

Electrical insulation test of alumina coating fabricated by sol–gel method in molten PbLi pool

New technology and application development of alkoxide-derived high purity alumina

Synthesis of submicronic α-alumina from local aluminum slags

Synthesis and characterization of activated alumina with high thermal stability by a low-heat solid-phase precursor method

Application of Liquidus Projections in SiO 2 -Al 2 O 3 -CaO Systems with Fe 2 O 3 and V 2 O 5 to Study the Dissolution of Alumina Crucibles in Gasification Slags Containing Vanadium

Preparation of High Thermal-Stabile Alumina by Reverse Microemulsion Method

The Influence of Alumina to Microstructure and Dielectric Properties for Low Temperature Co-Fired Ceramics

Porous MgO-based ceramics synthesized by the volume expansion effect: Designing and performance

Improved Mechanical Properties of Alumina Ceramics Using Plasma-Assisted Milling Technique

An easy approach to adjust microstructure and physical properties in alumina

Microwave dielectric properties of a novel Li2O–Al2O3–B2O3 glass-ceramic for ULTCC application

Elaboration of alumina-based materials by solution combustion synthesis: A review

Preparation of Alumina Ultrafine Powders Through Acrylamide, Starch and Glutaric Dialdehyde Mediated Sol–gel Method

Alumina Ceramic Nanofibers: An Overview of the Spinning Gel Preparation, Manufacturing Process, and Application

Highly Porous and Hierarchical MgAl2O4 Ceramics with Improved Pore Connectivity Prepared from Gelled Particle-Stabilized Foams

Effects of glycerol addition on the slurry dispersion and mechanical properties of alumina ceramics prepared by gel-casting process

Preparation of low-shrinkage and high-performance alumina ceramics via incorporation of pre-sintered alumina powder based on Isobam gelcasting

Size-controlled synthesis and photoluminescence of porous monolithic α-alumina

A simple and efficient hydratable alumina gel‐casting method for the fabrication of high‐porosity mullite ceramics

A novel low thermal conductivity refractory aggregate for high-temperature applications: Lightweight microporous alumina-rich spinel (Mg0.4Al2.4O4)