Abstract:ABSTRACTThermally induced phase separation (TIPS) has been developed to prepare porous membranes. The porous structures are mainly dependent on diluents adopted in the TIPS process. We obtained two typical morphologies of poly(vinylidene fluoride) (PVDF) membranes using cyclohexanone (CO) and propylene carbonate (PC) as diluents, respectively. SEM observation displays that porous spherulites are formed from PVDF/CO system, whereas smooth particles result from PVDF/PC system. The TIPS processes of these two systems have been investigated in detail by optical microscope observation and temperature‐dependent FTIR combined with two‐dimensional infrared correlation analysis. Rapid crystallization of PVDF can be seen around 110 °C in the PVDF/CO system, which is consistent with the results of temperature‐dependent FTIR spectra. The spectral evolution indicates a transform of PVDF from amorphous to α‐phase after 110 °C. The νs(CO) band at 1712 cm−1 narrows and the νs(CF) band at 1188 cm−1 shifts to 1192 cm−1 before crystallization, which implies the destruction of interaction between PVDF and CO. In contrast, the PVDF/PC system shows slow crystallization with all‐trans conformation assigned to β‐phase and γ‐phase below 60 °C but no obvious change of polymer−diluent interaction. We propose two mechanisms for the different phase behaviors of PVDF/CO and PVDF/PC systems: a solid−liquid phase separation after destruction of polymer−diluent interaction in the former, and a liquid−liquid phase separation process coupled with rich‐phase crystallization in the later. This work may provide new insight into the relationship among morphologies, crystal forms, and phase separation processes, which will be helpful to adjust membrane structure. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013, 51, 1438–1447

Formation of Hydrophilic Ethylene-Acrylic Acid Copolymer Microporous Membranes Via Thermally Induced Phase Separation

Preparation of High Density Polyethylene/polyethylene- Block -Poly(ethylene Glycol) Copolymer Blend Porous Membranes Via Thermally Induced Phase Separation Process and Their Properties

Preparation of Porous PVDF Membrane Via Thermally Induced Phase Separation with Diluent Mixture of DBP and DEHP

Preparation of porous PVdF membrane via thermally induced phase separation using sulfolane

Preparation of Microporous Ultra High Molecular Weight Polyethylene (uhmwpe) by Thermally Induced Phase Separation of A Uhmwpe/Liquid Paraffin Mixture

Fabrication of Hydrophilic and Sponge-Like PVDF/brush-like Copolymer Blend Membranes Using Triethylphosphate As Solvent

MICROPOROUS PVDF-HFP-BASED POLYMER MEMBRANES FORMED FROM SUPERCRITICAL CO2 INDUCED PHASE SEPARATION *

Development of Polymer Microporous Membranes Via Thermally Induced Phase Separation

Effect of Diluents on Hydrophilic Ethylene-Acrylic Acid Co-Polymer Membrane Structure Via Thermally Induced Phase Separation

PVDF Membrane Formation Via Thermally Induced Phase Separation

Preparation of Ethylene Chlorotrifluoroethylene Co-polymer Membranes Via Thermally Induced Phase Separation

Formation of Isotactic Polypropylene Membranes with Bicontinuous Structure and Good Strength Via Thermally Induced Phase Separation Method

Preparation of PVDF-HFP Microporous Membranes via the Thermally Induced Phase Separation Process

Effect of Polypropylene Molecular Weight on Microporous Membrane Formation Via Thermally Induced Phase Separation

Polar Polymer Membranes Via Thermally Induced Phase Separation Using A Universal Crystallizable Diluent

FORMATION OF LOW DENSITY POLYETHYLENE MICROPOROUS MEMBRANES VIA THERMALLY INDUCED PHASE SEPARATION--(Ⅰ) LDPE-18D/DPE SYSTEM

Thermally Induced Phase Separation of Poly(vinylidene Fluoride)/diluent Systems: Optical Microscope and Infrared Spectroscopy Studies

Formation of microporous membrane of isotactic polypropylene in dibutyl phthalate-soybean oil via thermally induced phase separation

Preparation and Characterization of Cellulose Triacetate Membranes Via Thermally Induced Phase Separation

FORMATION OF LOW DENSITY POLYETHYLENE MICROPOROUS MEMBRANE VIA THERMALLY INDUCED PHASE SEPARATION--(Ⅱ) THE EFFECTS OF KINETIC FACTORS ON THE STRUCTURES OF MICROPOROUS MEMBRANES

Formation of anisotropic microporous isotactic polypropylene (iPP) membrane via thermally induced phase separation