Abstract:This paper aims to unveil effects of α colony and α plate parameters on tensile properties and impact toughness of Ti-55531 alloy with multilevel lamellar microstructures. Microstructures with different α colony and α plate sizes were prepared using varied heat treatments and analyzed by X-ray diffraction, scanning electron microscopy, electron back-scattered diffraction, transmission electron microscopy. Relationships of microstructure and strength, plasticity and impact toughness were discussed. Results indicate that tensile strength increases, while plasticity and impact toughness of the alloy decline with decreasing effective sizes (width/length ratio) of α colony (dc) and α plate (dα) and increasing of volume fraction of α phase. Both dc and dα follow the Hall–Petch principle with strength, and dc was determined to be the critical controlling parameter of strength owing to higher interfacial strengthening effect induced by α colony. However, plasticity is primarily related to dα. Moreover, impact toughness for both dc and dα follows the linear relation, but the coefficient of dα is higher. Furthermore, impact toughness is more dependent on plasticity than strength. Larger α plates lead to more mechanical twins during impacting and result in higher plasticity and impact toughness. Therefore, the impact toughness should depend more on the size of α plates.Graphical abstractIn order to unveil the influence of α plate size on impact deformation and microcrack initiation behavior of Ti-55531 alloy, the microstructural deformation and crack nucleation characteristics in the impact crack nucleation region were detected by TEM in detail; then, the schematic illustration for microstructural deformation and crack nucleation characteristics was made according to experiment results.

Factors Affecting the Hall-Petch Relationship in Ti-Al Based Alloys

Hall–Petch relationship in two-phase TiAl alloys with fully lamellar microstructures

Hall–Petch relationship in Ti3Al nano-polycrystalline alloys by molecular dynamics simulation

Factors affecting the room-temperature tensile properties of TiAl alloys with fully lamellar microstructures

The relationships of microstructure and properties of a fully lamellar TiAl alloy

Influences of Grain Size on the Deformation Behavior of a Twinning-Induced Plasticity Metastable Β Titanium Alloy

Effect of Zr, Hf, and Sn Additives on Elastic Properties of Α2-Ti3al Phase by First-Principles Calculations

The Effect of Ti/Al Ratios on the Evolution of Precipitates and Their Effects on Tensile Properties for Fe3.75Cr1.25NiAl0.6-xTix High Entropy Alloys

High-temperature “Inverse” Hall-Petch relationship and fracture behavior of TA15 alloy

Deciphering the Quantitative Relationships Between Age-Induced Hierarchical Microstructure Characteristics and Tensile Properties of Ti20C Alloy

Tensile performance and impact toughness of Ti-55531 alloy with multilevel lamellar microstructure

Effect of Yttrium Addition on Microstructures and Room Temperature Tensile Properties of Ti-47 Al Alloy

Investigation of the Microstructures and Mechanical Properties of P/M Tial-Based Alloys

Grain Growth and Microstructure Evolution Based Mechanical Property Predicted by a Modified Hall–Petch Equation in Hot Worked Ni76Cr19AlTiCo Alloy

Temperature dependence of the Hall–Petch relationship in CoCrFeMnNi high-entropy alloy

Influences of Ti additions on the microstructure and tensile properties of AlCoCrFeNi2.1 eutectic high entropy alloy

Influence of Ti content on mechanical properties of low carbon steel

Factors affecting the lamellar spacing in two-phase TiAl alloys with fully lamellar microstructures

The Ambient Temperature Tensile Behavior of Duplex Γ-Tial-based Alloys

Grain growth and Hall–Petch relationship in Ti_37V_15Nb_22Hf_23W_3 refractory high-entropy alloys

Effects of Al on crack propagation in titanium alloys and the governing toughening mechanism