Abstract:The influence of asymmetric rolling on the microstructure, texture and mechanical properties of Al–Mg–Si alloy was investigated comprehensively through finite element simulation (FEM), microstructure and texture characterization, and tensile testing. Cold rolling was applied by imposing different velocity ratios (from 1 to 1.75) between the upper and lower rolls. The results show that asymmetric rolling has some effects on the shear strain, microstructure, texture and mechanical properties. The shear strain always exhibits a non-uniform distribution throughout the sheet thickness, and it is closely related to the velocity ratio; improving the velocity ratio could result in a larger shear strain in the surface contacting the roll with a higher velocity. As the velocity ratio increases, the cold rolled alloy sheet contains an increasing number of fine equiaxed grains, and the solution-treated recrystallization grain structure gradually becomes fine. Unlike symmetric rolling, asymmetric rolling can result in the development of TD-rotated β fiber, and the rotation angle is largely dependent on the velocity ratio. Although no ideal shear texture E {111}<110> and F{111}<112> orientations were developed, the shear texture H{001}<110> orientation appears by applying a sufficient velocity ratio. After solution treatment, the velocity ratio has no influence on the texture component, but improving the velocity ratio can reduce the texture volume fraction. Asymmetric rolling plays a positive role in improving mechanical property. As the velocity ratio increases, there are increases in the strength, elongation and plastic strain ratio R, and a decrease in the planar anisotropy ΔR, which is likely attributable to the weak texture.

Through Thickness Variation of Cross Shear Rolling Texture in Grain Oriented Silicon Steel

TEXTURE DISTRIBUTION AND DEVELOPMENT THROUGH THE THICKNESS AFTER CROSS SHEAR ROLLING OF GRAIN ORIENTED SILICON STEEL

Evolution of Texture in High Permeability Grain Oriented Silicon Steel Produced by Casting Thin Slab and Rolling Process

Texture and Microstructure Evolution During Different Rolling Methods in Strip-Cast Grain-Oriented 6.5% Si Steel

Effects of Strain Rate on Shear Bands and Texture Evolution in Grain-oriented Silicon Steel

Texture Distribution and Development through the Thickness of Grain Oriented Silicon Steel

Microstructure and Texture Evolution of Strip-Cast and Hot-Rolled Fe-3 %si Steel Sheet

Electron Backscatter Diffraction Analysis of Low-Misorientation-Angle Boundary and High-Energy Boundary in the Hot-Rolled Plate of Grain-Orientated Silicon Steel

Shear Texture Gradient in Aa6061 Aluminum Alloy Processed by Accumulative Roll Bonding with High Roll Roughness

Orientation relationship of texture development in hot-rolled W during annealing

Texture transition of shear bands in initially Goss–oriented grains in Fe–3 wt%Si alloy

Influence of Cold Rolling Direction on Texture, Inhibitor and Magnetic Properties in Strip-Cast Grain-Oriented 3% Silicon Steel

Experimental investigation and simulation of crystallographic orientations evolution in a cold-rolled ultra-thin grain-oriented silicon steel

Study on the recrystallization microstructure and texture evolution of a rolled 0.075 mm ultra-thin grain-oriented silicon steel

Effect of Slab Reheating Temperature on Cold Rolling Texture Evolution of Nb-Containing Grain-Oriented Silicon Steel

Texture Evolution during Recrystallization and Grain Growth in Non-Oriented Electrical Steel Produced by Compact Strip Production Process

Influence of Asymmetric Rolling on the Microstructure, Texture Evolution and Mechanical Properties of Al–Mg–Si Alloy

Microstructure and texture evolution of strip casting 3 wt% Si non-oriented silicon steel with columnar structure

Microstructure and texture evolution of ultra-thin grain-oriented silicon steel sheet fabricated using strip casting and three-stage cold rolling method

Texture evolution during multi-pass cold rolling and annealing of Ti-2Al-1.5Mn alloy

The Early Stage Formation of Shear Orientations and the Stability of //ND Orientations During Hot Rolling in Electrical Steels