Numerical Simulation of Dendrite Growth of Aluminum Alloy

QY Xu,WM Feng,BC Liu,SM Xiong
DOI: https://doi.org/10.3321/j.issn:0412-1961.2002.08.003
IF: 1.797
2002-01-01
ACTA METALLURGICA SINICA
Abstract:Microstructure modeling of aluminum alloy casting has been carried out by using a new stochastic modeling method coupled with macro heat transfer calculation. The physical model and mathematical model for the simplified dendrite shape were established, in which a shape function was presented to describe the dendrite shape contour. On the basis of the simplified grain shape, a coordinate transformation method was used to describe the equiaxed grain growth in the undercooled melts and the node capturing during the further growth of a grain. According to the above model, the microstructure simulation scheme was developed to model the grain formation. Two-dimensional calculations were performed to simulate the evolution of equiaxed dendritic morphologies. In order to verify the modeling results, the castings were cast in sand mold and metal mold. Simulation results show that grain size is smaller for metal mold casting, but larger for sand mold casting, which is in good agreement with the experimental results.
What problem does this paper attempt to address?