Abstract:The solute segregation and redistribution during non-equilibrium rapid solidification using laser additive manufacturing (LAM) process directly influence the microstructure morphology and phase distribution, which in turn affects their mechanical properties. In this work, a laser micro-alloying strategy was utilized to preserve the original solidification microstructure in the considered Ti-9Mo, Ti-9Cr, Ti-9Fe, and Ti-9Ni (wt%) alloys. The addition of different β-stabilizing elements (Mo, Cr, Fe, and Ni) resulted in distinct microstructures: Ti-9Mo and Ti-9Cr alloys exhibited larger grains (∼502 μm and ∼733 μm) and cellular morphologies due to minimum constitutional undercooling at the solid-liquid interface. Because of the increased constitutional undercooling, the Ti-9Fe grains are significantly refined (∼398 μm), showing a dendritic morphology with elongated primary dendrite arms. Ti-9Ni exhibited the highest constitutional undercooling, forming equiaxed dendrites. However, due to the significant consumption of solute atoms by the interdendritic eutectic phase Ti 2 Ni, the grains did not further refine (∼396 μm). Combined with the temperature field simulation, the solidification conditions of the alloys were determined. In addition, based on the solute partitioning coefficients ( k ), the different solute redistribution and diffusion behaviors at the solid-liquid interface during the laser micro-alloying process of Ti-9Mo with k > 1 and Ti-9Cr with k < 1 were elucidated, providing essential insights into the formation of typical cellular morphology and enhanced Mo enrichment phenomenon in the Ti-9Mo alloy.

Laser Rapid Surface Remelting of Cu-Mn Alloy

Rapid directional solidification with ultra-high temperature gradient and cellular spacing selection of Cu-Mn alloy

Microstructure Evolution of Cu-Mn Alloy under Laser Ultra-High Temperature Gradient and Rapid Solidification Condition

Cellular Spacing of Cu-Mn Alloy under Ultrahigh Temperature Gradient and Rapid Directional Solidification

Research on Laser Rapid Directional Solidification with Ultra-highTemperature Gradient

Microstructure Characteristics of Cu31.4%Mn Alloyunder Laser Rapid Solidification Condition

The Effect of Laser Remelting in the Formation of Tunable Nanoporous Mn Structures on Mild Steel Substrates

Rapid Solidification Structure Refinement Mechanism in Highly Undercooled Cu Based Ternary Alloys

Crystal Structure Transformation of Laser Cladded Mn-Cu Alloy Coatings Induced by Electrochemical Etch

Development of Microstructures in Laser Surface Remelting of Dd2 Single Crystal

Laser Cladding Fe/FeCr Coatings on Continuous Casting Cu Mold

Epitaxial growth behavior and stray grains formation mechanism during laser surface re-melting of directionally solidified nickel-based superalloys

Laser–Direct Current arc Hybrid Additive Manufacturing of Cu-Cr-Zr Alloy: Microstructure Evaluation and Mechanical Properties

Microstructure Investigation of Laser Cladded Mn-Cu Alloy Coatings in Electrochemical Etch

The mechanical and functional behaviors of Mn–15 wt.%Cu alloy produced by selective laser melting

Microstructure and Application of Surface after Laser Alloying on Surfacing Layer

Epitaxial growth in 316L steel and CoCrFeMnNi high entropy alloy made by powder-bed laser melting

Understanding the solute segregation and redistribution behavior in rapidly solidified binary Ti- X alloys fabricated through non-equilibrium laser processing

Microstructure and Wear Behavior of Laser-Remelted High-Manganese Steel

Comparative Study on the Surface Remelting of Mo-Si-B Alloys with Laser and Electron Beam

Microstructure Prediction of Laser Surface Remelting Zone of Single Crystal Alloy Dd2