Simplified decoupling simulation study of non‐contact voltage measurement in distribution station area
Lina Liu,Tao Wang,Jie Shen,Ruichao Li,Fangshuo Li,Ming Qu,Xiaojun Li
DOI: https://doi.org/10.1049/gtd2.13124
2024-03-10
IET Generation Transmission & Distribution
Abstract:In non‐contact voltage measurements on low‐voltage three‐phase power lines, the coupling capacitances between neighboring lines, as well as spaced lines and sensors, are not negligible. This leads to an increase in the number of unknown capacitances. The number of associable response voltage equations is less than the number of unknown coupling capacitances. This paper proposes a simplified decoupling method for non‐contact voltage measurement based on the erection characteristics of triangular three‐phase lines in distribution areas. Firstly, establish the equivalent circuit of voltage sensing mechanism measurement during three‐phase operation, and derive the three‐phase line response voltage equation. Secondly, this paper proposes a three‐phase line response voltage decoupling algorithm after designing the decoupling matrix. The three‐phase coupling equation is decoupled into three independent equations. This paper then uses the least squares method to solve the coefficients in the equation. Finally, the three‐phase voltage fluctuation in the actual low‐voltage station area is simulated by simulation. The measured sensor voltage values are substituted into the algorithm to invert and calculate the three‐phase line voltage. The three‐phase phase error is less than 2°? The amplitude error is less than 1.77%. This experiment verifies the robustness and accuracy of the proposed inversion method. This in turn proves the practicality of the three‐phase simplified decoupling method in this paper. The coupling capacitance between the line and the transducer cannot be ignored when making non‐contact voltage measurements on low‐voltage three‐phase power lines. This leads to an increase in the number of unknown capacitances, and the number of correlatable response voltage equations is less than the number of unknown coupling capacitances. In this paper, a simplified decoupling method is proposed based on the characteristics of triangular three‐phase lines erected in distribution areas. Firstly, the equivalent circuit measured by the voltage sensing mechanism during three‐phase operation is established, and the three‐phase line response voltage equation is derived. Secondly, this paper proposes a three‐phase line response voltage decoupling algorithm after designing the decoupling matrix. Then, this paper uses the least squares method to solve the coefficients in the equations. Finally, the three‐phase voltage fluctuations of the actual low‐voltage stations are simulated by simulation. The measured sensor voltage values are substituted into the algorithm to invert and calculate the three‐phase line voltage. The three‐phase phase error is less than 2°. The amplitude error is less than 1.77%. The experiment verifies the stability and accuracy of the proposed decoupling method.
engineering, electrical & electronic