Abstract:Maintaining stability remains a crucial issue for the safety of underwater vehicles, especially during high-speed navigation where flow cavitation may occur. Cavitators are small protrusions on the hydrofoil surface, which can be used to control the patterns of flow cavitation. In this study, we investigate the effect of cavitators on supercavitating flow and hydrodynamic forces for high-speed hydrofoil. The volume of fluid method and the large eddy simulation turbulence model with the Kunz cavitation model are used in the simulations in order to accurately capture the interface between two phases (water and vapor) and the region of flow supercavitation. To validate the numerical method, the time-averaged simulated results of the supercavitating flow over a wedge-shaped hydrofoil are compared and validated against the experimental data by Kermeen ("Experimental investigations of three-dimensional effects on cavitating hydrofoils," Technical Report No. 47-14, Engineering Division of the California Institute of Technology, Pasadena, CA, 1960). Then, the numerical method is used to simulate the supercavitating flow of two-dimensional and three-dimensional cases with and without the cavitator placed on the lower side of the hydrofoil. The simulations were conducted for the cavitator located at the 1/32, 1/16, 1/8, and 1/4 chord of the hydrofoil at various angles of attack 1°–12° and cavitation numbers at 0.1, 0.2, and 0.4. A detailed analysis is made to examine the relations between cavitation pattern, hydrodynamic forces, and cavitator placement location. Compared to the cases without the cavitator, the supercavitating flow over the hydrofoils controlled by the cavitator demonstrates a significant difference in lift, whereas the drag does not change much. The changes in lift are closely related to the cavitator location. These findings can serve as a good guidance on how to improve the hydrodynamic performance and stability condition of a high-speed hydrofoil/wing using the cavitator.

DESIGN OF CAVITATING PROPELLERS BY LIFTING SURFACE THEORY

A Design Method of Ducted Propeller by Coupled Lifting Surface Theory/Panel Method

Numerical study of the hydrodynamic performances of surface piercing propeller

Design Method of Water Jet Pump Towards High Cavitation Performances

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

DESIGN OF OPEN-WATER AND WAKE-ADAPTED OPTIMUM PROPELLERS BASED ON A VORTEX LATTICE LIFTING-SURFACE MODEL

A New Design Method for Ship Propellers with Prescribed Circulation Distributions Based on the Vortex Lattice Lifting-Surface Model

Improvement to a Design Method for Highly Skewed Contra-Rotating Propellers of Underwater Vehicles

Hybrid Aerodynamic Optimization of a Propeller Based on the Reformulated Blade Element Momentum Theory

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Research on Optimized Design of the Pitch and Camber of Marine Propellers

Lifting Surface Optimization of Wake-Adapted Propeller by Surrogate Model

Hydrodynamic Design of an Advanced Submerged Propulsion

A Vortex-Lattice Modeling Approach for Free-Surface Effects on Submerged Bodies and Propellers

Camber lines design approach of propeller blade sections based on the vortex lattice method

Design of Wake-Adapted Contra-Rotating Propellers for High-Speed Underwater Vehicles

Design and optimization of super-large capacity submersible axial-flow pump impeller

Dynamics of the supercavitating hydrofoil with cavitator in steady flow field

Prediction of Hydrodynamic Performances of Ducted Controllable Pitch Propellers

Numerical Study of Cavitating Turbulent Flow Around Propellers: Relationship of Cavity Volume Evolution and Pressure Fluctuation

Spatial Fluctuating Pressure Calculation of Underwater Counter Rotating Propellers under Noncavitating Condition