Abstract:This paper considers the necessary conditions for using a derivative of a transient hot-wire (termed a needle probe) approach to measure the thermal conductivity of electrically conducting fluids at high temperatures, especially molten halide salts. The focus is on the development of a new theory based on a multi-layer system necessary to ensure electrical isolation of electrical wires from the surrounding fluid. This includes the use of a thin annulus of fluid to minimize convective heat transfer modes within the fluid of interest, which was inspired by the concentric cylinder method. Good measurements require the following considerations: concentricity of the probe and surrounding crucible to ensure a consistent fluid gap, accounting for corrections for deviation of the model at early times, and modeling radiation heat transfer through transparent fluids. Uncertainties are larger than transient hot-wire methods because of the deviations from experimental conditions that can easily match an analytical approximation. An appropriate estimation of the measurement uncertainty can be obtained through careful design of the instrumentation, thorough uncertainty analysis, and limiting the measurements to only the applicable thermal property ranges of the approach. The 1D model used to interpret measured temperature data has been shown to be reliable for thermal conductivity measurements ranging from at least 0.39 W (mK −1 ) to 0.92 W (mK −1 ) and for temperatures from 293 K to 1023 K. The approach is used to present thermal conductivity data of the molten salts NaCl–KCl (51–49 mol%) and LiCl–NaCl (72–28 mol%).

Combination Of Hot/Cold Wire Technique For Instantaneous Velocity And Temperature Measurements

Combination of Hot/Cold Wires for Non-Isothermal Flow Measurements

A New Method for Flow Rate Measurement in Millimeter-Scale Pipes.

A New Contactless Method For Velocity Measurement Of Bubbleand Slug In Millimeter-Scale Pipelines

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

Experimental and Numerical Flow Visualizations of Mixed Convection with Flow Reversal in a Horizontal Channel with Constant Wall Temperature

A numerical investigation of conjugate forced heat transfer for a micro thermal flow sensor

Study on new gas flow sensor based on hot-film probe

Phase-average Analysis of Three-Dimensional Vorticity and Temperature Dissipation Rate in the Near Field of a Heated Circular Cylinder Wake

A Switched Vibrating-Hot-wire Method for Measuring the Viscosity and Thermal Conductivity of Liquids

Simultaneous measurements of thermal conductivity and thermal diffusivity of liquids under microgravity conditions

Simultaneous Measurements of the Thermal Conductivity and Thermal Diffusivity of Molten Salts with a Transient Short-Hot-Wire Method

Flow-Independent Thermal Conductivity and Volumetric Heat Capacity Measurement of Pure Gases and Binary Gas Mixtures Using a Single Heated Wire

Experimental Study on Flow Boiling Heat Transfer of High-Pressure Water in Microtube with Coiled Wire Inserted

Experimental investigation on heat transfer characteristics of magnetic fluid flow around a fine wire under the influence of an external magnetic field

An in-depth numerical and experimental analysis of wire coil inserts: enhancing thermal performance and fluid flow characteristics in double pipe heat exchangers

SIMULTANEOUS ESTIMATION OF INLET TEMPERATURE AND WALL HEAT FLUX IN TURBULENT CIRCULAR PIPE FLOW

Mechanism and experimental study of thermal mixing of fluid with different temperature

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Numerical study on heat transfer characteristics of molten salt in annular channel with wire coil