Abstract:As the 100 Gbit/s Ethernet(100 GbE) has gradually become a commercial reality,the next step of migration is toward 1 Tbit/s Ethernet transport.Coherent optical orthogonal frequency division multiplexing(CO-OFDM) has recently drawon much attention to improve system capacity and transmission distance over fiber for its superior performance in spectrum efficiency,robust chromatic dispersion(CD) tolerance,receiver sensitivity,and polarization mode diversity(PMD) resilience,which has also been considered as a promising candidate for long-haul transmissions.In conventional optical OFDM systems,analog-to-digital converter(ADC) and digital-to-analog converter(DAC) are needed at transmitter and receiver,respectively.However,the radio frequency(RF) bandwidths and sampling rates of ADC and DAC are limited by current manufacturing.To overcome this problem,an 8×112 Gbit/s all-optical OFDM transmission system is proposed in this paper.A single laser source is utilized to generate frequency comb source as the sub-carriers of the proposed all-optical OFDM system with frequency spacing of 28 GHz by differential Mach-Zehnder external modulator.Each of 8 carriers of the comb source is encoded with 112 Gbit/s polarization division multiplexing quadrature phase shift keying(PDM-QPSK).At the receiver,optical fast Fourier transform(FFT) is performed by cascaded Mach-Zehnder delay interferometers(MZDIs) to de-multiplex the all-optical OFDM signal into 8 lower bit rate sub-carrier tributaries which can then be individually processed electronically.The back-to-back simulation results show that the optical signal-to-noise ratio(OSNR) penalty of 8×12 Gbit/s all-optical OFDM is about 9 dB compared with 112 Gbit/s single carrier system at bit error rate(BER) of 10-3,and its is available to update the current single carrier system using all-optical OFDM and common coherent optical receiver while without introducing signal impairment.

10Ghz Frame Clock Extraction Technology for 4×10gbit/s OTDM System

4×10Gbit/s OTDM transmission with unequal amplitude coding methods over 122km single mode fiber

2.5 GHz Clock-Extraction from 8×2.5 Gbit/s OTDM System Employing Electrical Filter with High Q Value

In-band clock distribution concept for ultra-high bit rates OTDM system

Self-Clocking Based on In-Band Pilot for Ultra-High Bit Rates Otdm System

8× 112 Gbit/s All-Optical OFDM Fiber Transmission System Based on Optical FFT

Demonstration of a 16×10-Gb/s OTDM system

Demonstration of a 16*10-Gb/s OTDM System

Demonstration of an 8 × 10 Gb/s OTDM system

Realizing 20 Gbit/s OTDM transmission over 50 km true-wave filter with dispersion compensation

A 25-Ghz Ultra-Short Optical Pulse Source Applicable for 200-Gb/s OTDM Transmission over 300Km

All Optical Clock Extraction and Demultiplexing in 4×10 GHz OTDM System

All Optical Clock Extraction And Demultiplexing In 4x10ghz Otdm System

200Gs/s Real-time Optical-Sampling-based Orthogonal Frequency Division Multiplexing System

Effective Optical Clock Recovery and Simultaneous Fourfold Demultiplexing of Otdm Signal Using an Optoelectonic Oscillator

High-speed Optical Signal Processing for Telecom Applications

Demonstration of an 8×25-Gb/s Optical Time-Division Multiplexing System

A Novel Approach To Clock Division And Frame Clock Extraction

Clock extraction from 10 Gbit/s NRZ data and data format conversion using an opto-electronic oscillator

Fast-synchronization and Low-Timing-jitter Self-Clocking Concept for 160 Gbit/s Optical Time-Division Multiplexing Transmissions

All Optical Frame Clock Extraction with Polarization Flag in OTDM System