Abstract:To promote the innovation of raw magnesium production technology, an integrated calcination and silicothermic reduction short process for magnesium production was experimentally studied on the laboratory scale in this article. The influences of the thermal decomposition temperature, silicothermic reduction temperature, pelletizing pressures and silicon ratio on the characteristics of producing the magnesium by the short process was studied. The crosslinking effect, including reactions between CO2 decomposed from dolomite and metal elements in ferrosilicon, microstructure change at thermal decomposition and silicothermic reduction stages, was analyzed and discussed. In addition, comparison of the magnesium reduction rate and production efficiency between the new short process and the traditional Pidgeon process was made. The results indicated that the decomposition and reduction temperatures have a more significant influence on the magnesium reduction process than the pelletizing pressure and silicon ratio. A decomposition temperature < 1000 °C and reduction temperature > 1100 °C was proven to be favorable for improving the magnesium reduction rate and production efficiency of the new short process. It was also found that the integrated short process for magnesium production can reach the same total reduction rate and has lower efficiency compared to the traditional process. The decrease of magnesium production efficiency in the new short process was expected to result from reduction of the contact area and hindering of diffusion between CaO·MgO molecules and Si(Fe) atoms because of the microstructure change and ferrosilicon consumption by the reactions between CO2 and metal elements in ferrosilicon. Preparing briquettes with additives of binder or ultrafine particles of raw materials was proposed and considered for further study to improve the production efficiency.

Improvement on the Processes of MgO Manufacture

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Who Does Better for In-Situ Eutrophic Remediation in Anoxic Environment Improvement and Nutrient Removal: MgO2 Versus CaO2

Preparation of MgO with low CaO content and high specific surface area from low-grade dolomite

Improved Lime Method to Prepare High-Purity Magnesium Hydroxide and Light Magnesia from Bischofite

Preparation of light magnesia by using industrial waste alkali and brine

Technology of Preparation for Light Magnesium Oxide from Bischofite

Optimization of pyrolysis for MgO recycling in magnesia-based flue gas desulfurization

Research on Recovery of MgO by Desulfurization By-Product of Magnesium Oxide

Preparation of High-Purity Magnesia by Solid Phase Reduction Decomposition of Magnesium Sulfate

Chemical Structure Change of Magnesium Oxide in the Wet Oxidation Delignification Process of Biomass with Solid Alkali

Preparation of high-quality magnesium hydroxide with boron slurry and waste sulphuric acid from storage batteries

Recovery of SO2 and MgO from By-Products of MgO Wet Flue Gas Desulfurization.

Environmental Benign Preparation of Nanometer MgO

Preparation of Light Magnesium Carbonate from Magnesium Sulphate Waste Liquor

Preparation of nano-sized magnesia with industrial oxalic acid and magnesium hydroxide

Experimental Study of Magnesium (Mg) Production by an Integrated Calcination and Silicothermic Reduction Short Process

Preparation of high-purity light magnesia from sulfate salt subtype salt lake brine

Study on the Recovery of Magnesium Sulfate Heptahydrate from Brine Sludge Produced in Soda Industry

Preparation of High-Purity Magnesia by Carbon Monoxide Reduction Pyrolysis of Magnesium Sulfate

Mechanism and technology of recovery flue gas desulphurization with magnesium oxide