Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Research on Recovery of MgO by Desulfurization By-Product of Magnesium Oxide

Mechanism and technology of recovery flue gas desulphurization with magnesium oxide

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Technical and economic feasibility analysis of recovery flue gas desulphurization with magnesium oxide

Study on the characteristics of flue gas desulfurization by magnesium oxide

Experiment and Mechanism Analysis of Desulfurization with a MgO-Based Desulfurizer Fixed Bed Method

Study on the Reaction Characteristics of Flue Gas Desulfurization by Magnesia

STUDY ON THE INFLUENCE OF MAGNGNE SIUM OXIDE UPON QUALITY OF HYDRATED LIME IN DRY FGD SYSTEM

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

The Leaching and Kinetics of Magnesium in Phosphate Ore Slurry During FGD Process

Kinetics and Mechanism of Sulfite Oxidation in the Magnesium-Based Wet Flue Gas Desulfurization Process

Recovery of Magnesium Sulfate Through Crystallization in Waste Liquid after Simultaneous Desulfurization and Denitrification

Recovering chemical sludge from the zero liquid discharge system of flue gas desulfurization wastewater as flame retardants by a stepwise precipitation process

Ore sintering flue gas desulfurization and its resoureilization by using pyrolusite

LEACHING PERFORMANCE OF MAGNESIUM IN THE FGD PROCESS USING PHOSPHATE ORE SLURRY

Uniform Dispersion of Cobalt Nanoparticles over Nonporous TiO2 with Low Activation Energy for Magnesium Sulfate Recovery in a Novel Magnesia-Based Desulfurization Process

Flue gas desulfurization by natural recyclable manganese ore in packed bed reactor and its performance prediction by random pore model

Removal and Resource Utilization of High Concentration Flue Gas Sulfur Dioxide Using Manganese Carbonate Ore

Manganese Ore-based Wet Flue-Gas Desulfurization: A Review

The Formation of Manganous Dithionate in the Manganese Oxide Flue Gas Desulfurization

Study on magnesium reduction process for air-cooled high magnesium-bearing blast furnace slag