Abstract:The calculation reliability of pressure drop and gas–solid drag force in horizontal dilute phase pneumatic conveying strongly depends on the accuracy of gas–solid velocity correlation. However, there are limited studies on the solid velocity in horizontal dilute phase pneumatic conveying and it is important to further validate suitability of existing correlation of gas–solid velocity, especially for fine particles (such as pulverized coal). Consequently, in this paper, a negative pressure pneumatic conveying test rig is set up and two kinds of powders with different sizes are adopted. Optical fiber probe (OFP) was used to measure the volumetric solid concentration and particle velocity. The volumetric solid concentration was also calculated by using the measured particle velocity. The results show that the solid concentrations obtained by the two methods have good agreement, and discrepancy is within ±20%. It was found the particle velocities are different in the upper and lower part of the cross-section in the horizontal pipe. However, the difference is generally no more than 2m/s. The velocity difference will decrease with the increasing gas velocity, and increases with the solid mass flow rate. In the experimental condition of 0.06mm<ds<0.35mm, 1400kg/m3<ρs<2600kg/m3, the implicit correlation based on Yang's Unified Theory gives the best prediction of particle velocity among existing studies but still with noticeable discrepancy with the comparison of the present experimental data. By modifying the solid friction factor, an improved correlation of the particle velocity was obtained, which agrees better with the experimental data given in the present and literature studies.

APPLICATION OF L-VALVE IN PNEUMATIC CONVEYING

Experimental Study on Vertical Dilute Phase Gas Conveying

Improved particle plug valve for Geldart-D powders

Pressure Drop Characteristics of Vertical Dilute-phase Gas Conveying

Study on ultrahigh pressure and large flow rate pneumatic on-off valve

Numerical Simulation of the Gas-Solid Flow Around the Valve of Pneumatic Conveying System

Introduction of particle plug valve

The Effect of the Ratio of Initial Gas and Particle Velocity on the Particle Velocity in Pneumatic Conveying System

Flow Characteristics and Pressure Drop Across the Laval Nozzle in Dense Phase Pneumatic Conveying of the Pulverized Coal

Research on the Property of Velocity Variance for Crowded Particles in Pneumatic Conveying System

Application of particle plug valve in a positive dilute gas-conveying system

Fluid Dynamics Analysis and Optimized Throttling Design of L-shaped Multi-Stage High Pressure Reducing Valve

Experimental Investigation on Pressure Drop of Dense-Phase Pneumatic Conveying of Pulverized Coal in Vertical Pipeline

Design Optimization of a Venturi Tube Geometry in Dense-Phase Pneumatic Conveying of Pulverized Coal for Entrained-Flow Gasification

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

Flow Characteristics and Flow Rate Prediction of Pulverized Coal Through a Regulation Valve

Development of System Design Module in Low-velocity Slug-flow Pneumatic Conveying

Research on Resistance Properties for Dense Phase Pneumatic Conveying of Pulverized Coal in Vertical Pipe at Different Pressures

Study on the Characteristics of Self-Developed Pulverized Coal Flow Regulation Valve for Coal Gasification Process

Numerical simulation of dense-phase pneumatic conveying in vertical pipe for gasifier

Investigations of Pulverized Coal Pneumatic Conveying Using CO2 and Air