Abstract:The calculation reliability of pressure drop and gas–solid drag force in horizontal dilute phase pneumatic conveying strongly depends on the accuracy of gas–solid velocity correlation. However, there are limited studies on the solid velocity in horizontal dilute phase pneumatic conveying and it is important to further validate suitability of existing correlation of gas–solid velocity, especially for fine particles (such as pulverized coal). Consequently, in this paper, a negative pressure pneumatic conveying test rig is set up and two kinds of powders with different sizes are adopted. Optical fiber probe (OFP) was used to measure the volumetric solid concentration and particle velocity. The volumetric solid concentration was also calculated by using the measured particle velocity. The results show that the solid concentrations obtained by the two methods have good agreement, and discrepancy is within ±20%. It was found the particle velocities are different in the upper and lower part of the cross-section in the horizontal pipe. However, the difference is generally no more than 2m/s. The velocity difference will decrease with the increasing gas velocity, and increases with the solid mass flow rate. In the experimental condition of 0.06mm<ds<0.35mm, 1400kg/m3<ρs<2600kg/m3, the implicit correlation based on Yang's Unified Theory gives the best prediction of particle velocity among existing studies but still with noticeable discrepancy with the comparison of the present experimental data. By modifying the solid friction factor, an improved correlation of the particle velocity was obtained, which agrees better with the experimental data given in the present and literature studies.

Research on the Property of Velocity Variance for Crowded Particles in Pneumatic Conveying System

The Effect of the Ratio of Initial Gas and Particle Velocity on the Particle Velocity in Pneumatic Conveying System

The effect of the ratio of initial gas and particle velocity on the acceleration of particle in a on spatial model

Research on the Motion of Cylindrical Particles in the Pneumatic Conveying System

Research on the motion of cylindrical particles in pneumatic conveying system

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Acoustic Analysis of Particle–Wall Interaction and Detection of Particle Mass Flow Rate in Vertical Pneumatic Conveying

Research on the Pneumatic Conveying Characteristics of Fly Ash in the Power Station

Research On The Motion Of Cylindrical Particles In The Pipe

Numerical Simulation of the Gas-Solid Flow Around the Valve of Pneumatic Conveying System

Study on Friction and Conveying Characteristics of the Pneumatic Logistics Transmission System

Study on Transport Characteristics of Grain Particles in Pneumatic Conveying

CFD–DEM Simulation of Pneumatic Conveying in a Horizontal Channel

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

Research on Stability of Dense Gas-particle Two-phase Jets

Numerical Simulation on Gas-Solid Two-Phase Flow in Horizontal Pneumatic Conveying Pipe Based on DPM Model

Velocity Distribution Under Critical Conditions of Dense Phase Pneumatic Conveying in a Bend Pipe

Modeling Study on the Pressure Drop and Characteristic Velocity of the Pneumatic Logistics Transmission System

Research on the Pressure Dropin Horizontal Pneumatic Conveying for Large Coal Particles

Measurement and Analysis of Flow Regimes Transition by Acoustic and Electrostatic Signals in Vertical Pneumatic Conveying

Particle dynamics analysis in bend in a horizontal-vertical pneumatic conveying system with oscillatory flow