Abstract:The calculation reliability of pressure drop and gas–solid drag force in horizontal dilute phase pneumatic conveying strongly depends on the accuracy of gas–solid velocity correlation. However, there are limited studies on the solid velocity in horizontal dilute phase pneumatic conveying and it is important to further validate suitability of existing correlation of gas–solid velocity, especially for fine particles (such as pulverized coal). Consequently, in this paper, a negative pressure pneumatic conveying test rig is set up and two kinds of powders with different sizes are adopted. Optical fiber probe (OFP) was used to measure the volumetric solid concentration and particle velocity. The volumetric solid concentration was also calculated by using the measured particle velocity. The results show that the solid concentrations obtained by the two methods have good agreement, and discrepancy is within ±20%. It was found the particle velocities are different in the upper and lower part of the cross-section in the horizontal pipe. However, the difference is generally no more than 2m/s. The velocity difference will decrease with the increasing gas velocity, and increases with the solid mass flow rate. In the experimental condition of 0.06mm<ds<0.35mm, 1400kg/m3<ρs<2600kg/m3, the implicit correlation based on Yang's Unified Theory gives the best prediction of particle velocity among existing studies but still with noticeable discrepancy with the comparison of the present experimental data. By modifying the solid friction factor, an improved correlation of the particle velocity was obtained, which agrees better with the experimental data given in the present and literature studies.

Improved particle plug valve for Geldart-D powders

Introduction of particle plug valve

Application of particle plug valve in a positive dilute gas-conveying system

Experimental Study on the Hung-Up Regime of a Hopper-Standpipe System for a Geldart-D Powder

APPLICATION OF L-VALVE IN PNEUMATIC CONVEYING

Acoustic Analysis of Particle-Wall Interactions of Plug Flow in Vertical Pneumatic Conveying

Incipient Condition of Hang-Up in A Long Standpipe-Hopper System for Geldart-D Powders

Experimental Investigation on Vertical Plug Formation of Coarse Particles by a Non-Mechanical Feeder

Powder Discharge from a Hopper-Standpipe System Modelled with CPFD

Study on Fine Powder Discharged from Hoppers Modified with Insert

Pressure Drop Characteristics of Vertical Dilute-phase Gas Conveying

Experimental Study on Plug Formation Characteristics of a Novel Draft Tube Type Feeder for Vertical Pneumatic Conveying of Coarse Particles

Optimization and analysis of the inflow distribution influence on the middle discharge blow tank pneumatic conveying characteristics

AN IMPROVED METHOD FOR MEASURING THE UNCONFINED YIELD STRENGTH OF POWDERS AGAINST NEGATIVE PRESSURE DROP

Compact Pneumatic Pulse-Jet Pump with Venturi-Like Reverse Flow Diverter

Experimental Study on Vertical Dilute Phase Gas Conveying

Powder Feeding Enhancement of Powder Propellant Supply System by Using Gas-Permeable Piston

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

Pressure Fluctuation Instability in Vertical Plug Formation of Coarse Particles with a Non-Mechanical Feeder

Fluidization of Coarse Powder in Tapered Beds