Abstract:Cohesive powders cannot flow freely in the silo and even behave like solid, which brings a great challenge to the powder handling process. Aeration is an effective method used to break the arch structure formed above the silo outlet and to promote the powder flow. However, it is difficult to determine the solid-liquid transition behaviors and to predict the critical arch-breaking gas flow rate in the aerated discharge systems. In this paper, cohesive powders including alumina (Al2O3), pulverized coal (COAL) and calcium carbonate (CaCO3) were used as experimental materials. Powder flow properties were characterized by conducting shear test, permeability test, and aerated discharge experiment. Unconfined yield strength of powders under zero pre-consolidated stress was obtained based on using a linear extrapolation procedure of shear parameters. Aerated discharge characteristics of cohesive powders were determined and, the critical condition corresponding to the transition from solid-like to liquid-state and the stable condition distinguishing the funnel flow pattern and mass flow pattern were defined, respectively. The Brown and Richards model, and the flow/no-flow criterion of Jenike were modified to describe the powder flow state and to predict the solid mass flow rate under the action of aeration by introducing the positive gas pressure gradient. A logical algorithm was proposed to predict the critical arch-breaking gas flow rate by assuming the same gas distribution coefficient under different aeration conditions. As a precondition, the critical solid mass flow rate was calculated by an iterative algorithm giving the same order of magnitude of that from the experiment, which was further related to the stable solid mass flow rate and the powder permeability index. This simplification provided us with satisfactory results for all the powders producing errors generally less than 30%, a more easy-to-operate method to determine the critical arch-breaking gas flow rate.

AN IMPROVED METHOD FOR MEASURING THE UNCONFINED YIELD STRENGTH OF POWDERS AGAINST NEGATIVE PRESSURE DROP

Acoustic Analysis of Particle–Wall Interaction and Detection of Particle Mass Flow Rate in Vertical Pneumatic Conveying

An Experimental Study on the Mechanics of Arching in Hoppers Connected to a Moving Bed with Negative Pressure Gradient

EFFECT OF SUDDEN CHANGE OF SOLIDS CIRCULATING RATE IN A MOVINGBED STANDPIPE ON THE WIDTH OF ARCHING AGAINST NEGATIVE PRESSURE GRADIENT

Study on solid-liquid transition behaviors of cohesive powders and predict the critical arch-breaking gas flow rate

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

Numerical Analysis of Air Effect on the Powder Flow Dynamics in the FT4 Powder Rheometer

Incipient Condition of Hang-Up in A Long Standpipe-Hopper System for Geldart-D Powders

Investigation of powder flowability at low stresses: Influence of particle size and size distribution

Characterization and flowability methods for metal powders

Improved shock-reloading technique for dynamic yield strength measurements

Pressure Drop Characteristics of Vertical Dilute-phase Gas Conveying

Improved particle plug valve for Geldart-D powders

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

MPFEM Investigation on Densification and Mechanical Structures During Ferrous Powder Compaction

Fluidization of Coarse Powder in Tapered Beds

Characterisation of gas-atomised metal powders used in binder jet 3D printing

Static Wall Pressure Distribution Characteristics in Horizontal Silos

Characterization of Non-Newtonian Rheological Behaviors of Powders

Experimental Study on the Hung-Up Regime of a Hopper-Standpipe System for a Geldart-D Powder

An Experimental Study on the Elbow Pressure Drop and Conveying Stability of Pneumatic Conveying for Stiff Shotcrete Based on Response Surface Methodology