Abstract:The direct DME synthesis from syngas was studied by using activated carbon-based bifunctional catalytic beds. Two kinds of activated carbons, prepared by physical (by CO 2 partial gasification) and chemical (with phosphoric acid) activation of olive stones, were used as supports for the preparation of the catalysts. The chemically activated carbon presented a considerable amount of thermally and chemically stable surface phosphorus complexes, which played an important role on the catalytic performance of the prepared catalysts. A Zr-loaded P-containing activated carbon presented a relatively high activity, selectivity and stability for the production of DME from methanol and was used as methanol dehydration catalyst. On the other hand, Cu-Zn was loaded on both P-containing and P-free activated carbon supports for the preparation of methanol synthesis catalysts. The presence of surface-phosphorus on the carbon support resulted in a strong metal-support interaction, hindering the catalytic activity for the hydrogenation of CO to methanol. However, the catalyst that did not contain phosphorus showed noticeable activity for this reaction. The physical mixing of the methanol synthesis and methanol dehydration catalysts resulted in the preparation of carbon-based bifunctional catalytic beds, which performed very efficiently in the direct DME synthesis from syngas in a fixed-bed reactor. Different mass ratios of the individual (metallic and acid) catalysts were studied. An acid/metallic catalyst mass ratio of 2 provided the catalytic bed with enough acid sites to promote methanol dehydration to its maximum extent and make the overall product distribution controlled by the methanol synthesis reaction on the metallic phase.

Study on Synergy Effect in Dimethyl Ether Synthesis from Syngas

Thermodynamics of the Single-Step Synthesis of Dimethyl Ether from Syngas

Enhancing Low-Temperature Methane Conversion on Zn/ZSM-5 in the Presence of Methanol by Regulating the Methanol-to-aromatics Reaction Pathway

Equilibrium calculations for direct synthesis of dimethyl ether from syngas

Experimental study of improved two step synthesis for DME production

Synergistic Effect of Zinc and Manganese in Cu-Mn-Zn/Y Catalyst for Syngas-to-dimethyl Ether

Dimethyl Ether Synthesis from CO2 Hydrogenation on a CuO−ZnO−Al2O3−ZrO2/HZSM-5 Bifunctional Catalyst

Direct synthesis of ethanol from dimethyl ether and syngas over combined H-Mordenite and Cu/ZnO catalysts.

One-step synthesis of dimethyl ether from biomass-derived syngas on CuO-ZnO-Al2O3/HZSM-5 hybrid catalyst: Combination method, synergistic effect, water-gas shift reaction and catalytic performance

Thermodynamic Simulation of Direct DME Synthesis via Biomass Gasification

Kinetic Study of Complete Liquid-Phase Catalyst for Dimethyl Ether Synthesis

Analysis of Chemical Equilibrium in Direct Synthesis of Dimethyl Ether from Syngas

Dimethyl Ether Synthesis from Methanol and Syngas over Different Sized HY Zeolite and Cu-Mn-Zn/HY Bifunctional Catalyst

Synthesis of dimethyl ether from greenhouse gas CO_2

Effect of the Addition of Manganese and Zinc on the Properties of Copper-Based Catalyst for the Synthesis of Syngas to Dimethyl Ether

Liquid-phase preparation of catalysts used in slurry reactors to synthesize dimethyl ether from syngas: Effect of heat-treatment atmosphere

Mechanism and catalytic performance for direct dimethyl ether synthesis by CO2 hydrogenation over CuZnZr/ferrierite hybrid catalyst

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

Optimizing CO 2 Hydrogenation to DME through Tailored Interfacial Interactions: Weakening Synergy in CuZnZr and Al-Modified SBA-15 Catalysts

Biomass-derived activated carbon catalysts for the direct dimethyl ether synthesis from syngas