Abstract:In this study, the effect of impeller meridional shape on the performance of axial-flow fan is investigated by CFD method. Three axialflow fan impellers with different meridional shapes are designed. The blade angle, blade stacking condition and other structure factors of the impellers are all remained consistent. The performance curves of the three impellers are calculated and compared. In almost all the interested flowrate range, the impeller W3 with an inverted-isosceles-trapezoid meridional shape and the longer blade camber achieves both the higher pressure rise and the higher efficiency than the other two impellers. A two-stage axial-flow fan designed on basis of W3 is manufactured and tested. Test results show good agreement with the calculated performance curves. Further, analyses of the CFD results are conducted to reveal the reasons for the different performance. A newly-defined Local Euler head (LEH) is introduced to represent the distribution of the major Euler work in the axial-flow fan. And the LEH distributions in the three impellers are obtained. W3 achieves the highest LEH at blade Trailing edge (TE), because it could perform the most Euler work to the fluid with the longest blade camber. Then losses in the impellers are analyzed by means of the entropy generation. Among the losses in impeller, the tip leakage loss and endwall friction loss are dominated at design flowrate. The generation condition of the tip leakage loss shows significant differences among the three impellers. And the whole power loss in impeller of W3 is slightly higher than those of the other two models. However, the power loss difference among the three impellers is negligible. And due to the highest shaft power, the efficiency loss of W3 is the lowest of all.

Effects of diffused meridional passage contour on loss

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Numerical Study on Meridional Passage Contour of Casing in an Inter-turbine Duct

Meridional Passage Contour of a Large Meridional Expansion Turbine

Numerical Investigation for Curved Guide Vane in Gas Turbine

Effect of Meridional Shape on Performance of Axial-Flow Fan

Effect of Flow Loss on Supporting Plate to Large Meridional Expansion Turbine

Influence of blade stacking line on loss in diffused meridional passage

Study on Leakage Loss Control Method of Circumferential Bending Clearance

Effects of Trailing Edge Cutback on the Aerodynamic Loss of a High Load Low-Pressure Turbine Blade Cascade

Calculation of the energy loss for tip leakage flow in turbines

Numerical simulation of the effects of trailing edge thickness on aerodynamic performance of low pressure turbine

A total three-dimensional evaluation method to analyze the loss mechanism of film cooling on turbine guide vane

Effects of deflected trailing edge on the aerodynamic performance of high-lift low pressure turbine cascades

Analysis of flow field structure and loss of high pressure guide vane

Numerical investigation of clocking effect on irreversible energy loss in volute for centrifugal pump with vaned diffuser based on entropy generation method

Study on influence of the construction change of the spiral casing and draft tube on the flow loss in low head Francis turbine

Investigation of Flow Control in Vane Guide Channel of a Large Meridional Expansion Turbine

Effect of Curved Blade on Flow Field in Turbine Stator under Different Incidences

Effects of the circumferential casing groove configuration on aerothermal performance of a transonic turbine stage

Experimental Investigation of Aerodynamic Characteristics of LP Turbine Guide Vane