Abstract:In this study, the effect of impeller meridional shape on the performance of axial-flow fan is investigated by CFD method. Three axialflow fan impellers with different meridional shapes are designed. The blade angle, blade stacking condition and other structure factors of the impellers are all remained consistent. The performance curves of the three impellers are calculated and compared. In almost all the interested flowrate range, the impeller W3 with an inverted-isosceles-trapezoid meridional shape and the longer blade camber achieves both the higher pressure rise and the higher efficiency than the other two impellers. A two-stage axial-flow fan designed on basis of W3 is manufactured and tested. Test results show good agreement with the calculated performance curves. Further, analyses of the CFD results are conducted to reveal the reasons for the different performance. A newly-defined Local Euler head (LEH) is introduced to represent the distribution of the major Euler work in the axial-flow fan. And the LEH distributions in the three impellers are obtained. W3 achieves the highest LEH at blade Trailing edge (TE), because it could perform the most Euler work to the fluid with the longest blade camber. Then losses in the impellers are analyzed by means of the entropy generation. Among the losses in impeller, the tip leakage loss and endwall friction loss are dominated at design flowrate. The generation condition of the tip leakage loss shows significant differences among the three impellers. And the whole power loss in impeller of W3 is slightly higher than those of the other two models. However, the power loss difference among the three impellers is negligible. And due to the highest shaft power, the efficiency loss of W3 is the lowest of all.

Effect of Flow Loss on Supporting Plate to Large Meridional Expansion Turbine

Investigation on root blade profile of a large meridional expansion turbine

Flow Separation and Control in Large Meridional Expansion Turbine

Investigation of Flow Control in Vane Guide Channel of a Large Meridional Expansion Turbine

Optimum Design on S1 Blade Profile of a Large Meridional Expansion Turbine

Design on Flow Separation and Control in Transition Section of a Large Meridional Expansion Turbine

Meridional Passage Contour of a Large Meridional Expansion Turbine

Effects of diffused meridional passage contour on loss

Effect of Meridional Shape on Performance of Axial-Flow Fan

Numerical investigation on bowed blades of large meridional expansion Turbine

Numerical Investigation of Flow and Loss in a Variable High-Pressure Guide Vane of 1＋1/2 Counter-Rotating Turbine

Secondary Flow Reduction By Blade Redesign And Endwall Contouring Using An Adjoint Optimization Method

Loss Analysis of a Mix-Flow Turbine with Nozzled Twin-Entry Volute at Different Admissions

Analysis of flow field structure and loss of high pressure guide vane

Experimental Investigation of Aerodynamic Characteristics of LP Turbine Guide Vane

Influence of blade stacking line on loss in diffused meridional passage

Large eddy simulations of the turbine vane pressure side film cooling flows of cylindrical and fan-shaped holes with a saw-tooth plasma actuator

Energy performance and flow characteristics of a pump-turbine under pump mode at different guide vane openings

Experimental Investigation on Flow Loss Characteristics Along Flow Direction of Large Enthalpy Drop Blade

Effects of mid-passage gap with a variable surface angle on a turbine vane endwall’s aerothermal and film cooling performances

Study on influence of the construction change of the spiral casing and draft tube on the flow loss in low head Francis turbine