Experimental and Numerical Investigation on Middle Passage Gap Leakage with Different Mass Flow Rate and Injection Angle on Turbine Endwall

Yu Song,Zhao Liu,Weixin Zhang,Yuqiang Ding,Zhenping Feng

DOI: https://doi.org/10.1016/j.ijheatfluidflow.2024.109533

IF: 2.643

2024-01-01

International Journal of Heat and Fluid Flow

Abstract:Regarding the actual installation feature of the blades and disk using tenon and mortise, the middle passage gap exists between the adjacent blades and the leakage flows out of the gap, cooling the endwall. To explore the balance between the aerodynamic and cooling performance on blade endwall in turbine cascade, this paper investigated the effect of middle passage gap leakage under various mass flow rate and injection angle configurations. Film cooling effectiveness measurement was performed with pressure-sensitive paint technique in a five-passages linear cascade. The mass flow ratio of middle passage gap leakage ranged from 0.5% to 1.5% with the injection angle (alpha m) m ) ranging from- 20 degrees degrees to 20 degrees. degrees . A combined approach utilizing numerical simulations to elucidate detailed aerodynamic loss mechanisms and experimental results of middle passage gap leakage was employed. The results show that increasing the mass flow rate of middle passage gap leakage does not suppress mainstream intrusion phenomenon. Cases with injection angle generally show improved cooling performance compared to the non-injection case (alpha m= m = 0 degrees). degrees ). The least improvements are 19% and 27.9% for mass flow rates of 0.5 % and 1.0 %, respectively. The case with an injection angle of 20 degrees degrees demonstrates the best comprehensive performance, achieving higher area-averaged cooling effectiveness and lower aerodynamic loss (1.2 % and 18.9 % decrease for mass flow rates of 0.5 % and 1.0 %).