High Temperature Mechanical Properties and Wear Performance of B4C/Al7075 Metal Matrix Composites
Sangmin Shin,Donghyun Lee,Yeong-Hwan Lee,Seongmin Ko,Hyeonjae Park,Sang-Bok Lee,Seungchan Cho,Yangdo Kim,Sang-Kwan Lee,Ilguk Jo
DOI: https://doi.org/10.3390/met9101108
IF: 2.695
2019-10-17
Metals
Abstract:In this study, high volume fraction B4C reinforced Al matrix composites were fabricated with a liquid pressing process. Microstructural analysis by scanning electron microscope and a transmission electron microscopy shows a uniform distribution of the B4C reinforcement in the matrix, without any defects such as pore and unwanted reaction products. The compressive strength and wear properties of the Al7075 matrix and the composite were compared at room temperature, 100, 200, and 300 °C, respectively. The B4C reinforced composite showed a very high ultimate compression strength (UCS) over 1.4 GPa at room temperature. The UCS gradually decreased as the temperature was increased, and the UCS of the composite at 300 °C was about one third of the UCS of the composite at room temperature. The fractography of the compressive test specimen revealed that the fracture mechanism of the composites was the brittle fracture mode at room temperature during the compression test. However, at the elevated temperature, AMCs had a mixed mode of a brittle and ductile fracture mechanism under the compressive load. The composite produced by a liquid pressing process also showed superior wear resistance compared with the Al matrix. The result of the wear test indicates that the wear loss of the Al matrix at 300 °C was two times higher than that of the AMCs, which is attributed to the formation of a mechanically mixed layer (MML) in the composites at the high temperature.
materials science, multidisciplinary,metallurgy & metallurgical engineering