Abstract:Atmospheric pressure gliding arc discharge has a wide range of applications in the fields of energy environment and material processing. During the discharge process, with the conversion of the gliding arc discharge mode, for the driving power supply, the output of the discharge process is from an open circuit to a near short circuit. There are two kinds of work. The switching of states requires an additional design of overcurrent-short-circuit protection methods suitable for gliding arc discharge applications. The nanosecond pulse power supply is the most potential excitation power source in the field of gliding arc discharge, and has broad application research prospects. In order to solve the problem of overcurrent and short circuit at the output terminal caused by gliding arc discharge, this paper proposes an over-current-short-circuit protection solution based on a Marx generator-based nanosecond pulse power current-limiting protection module and an automatic quick-cutting protection module. By analyzing the working process of the Marx pulse power supply and the working characteristics of the MOSFET, a current-limiting scheme to transfer the switch from the saturation region to the variable resistance region is designed, and the calculation method of the parameter design of the current-limiting resistor network is designed. At the same time, in order to solve the problem that the current-limiting protection scheme cannot cope with the normal short-circuit of the output terminal, an automatic quick-cut protection module is designed, including a short-circuit detection circuit, a fault latch circuit and an action circuit, which realizes the high-reliability triggering of the short-circuit fault signal, thereby solving the problem of a normal short-circuit at the output terminal. Finally, through the simulation experiment method, the feasibility of the over-current short-circuit protection scheme proposed in this paper is verified.

Crowbar Circuit Protection of High Voltage Power Supply of Plasma Filled HPM Source

Protection of the Power Klystron with Fast Protection Crowbar Technology

AC/DC Power Modulation for Corona Plasma Generation

A High-Voltage Pulse Generator for Corona Plasma Generation

Microwave Tube Fault-Current Model for Design of Crowbar Protection

Investigation on 10/350 Crowbar Pulse Current Circuit

A 10 Kw High-Voltage Pulse Generator for Corona Plasma Generation

10/350-$\Mu\hbox{s}$ Crowbar Pulse Current System

Comparison of Two-Type Corona Plasma Energization Techniques: Ultra-Short and DC/AC Power Sources

Evaluation of Pulsed Power Sources for Plasma Generation

High-voltage and High-Current Crowbar System Based on Pseudospark Switches: from System Design to Verification

Research on the Overcurrent-Short Circuit Protection Method of Nanosecond Pulse Power Supply Applied in the Field of Gliding Arc Discharge

Improved Control Strategy of an Active Crowbar for Directly-Driven PM Wind Generation System under Grid Voltage Dips

Transient analysis of the output short-circuit fault of high power and high voltage DC power supply

Design And Test Of Unified Power Flow Controller Protection Circuits

A Novel Crowbar Impulse Current Circuit for Testing the Switch-Type SPD

Development of the Plasma Limiter for High Power Microwave Weapon Protection

Experimental Study of the Plasma Cathode Electron Gun

Design on Thin Wire of Wire Burn Test for the High Voltage Power Supply Breakdown

Simulation of Simplified Cascade Waveguide Plasma Limiter under High Power Microwave

Design and testing of 45 kV, 50 kHz pulse power supply for dielectric barrier discharges