Abstract:To reduce the deformation and improve the quality of thin-walled parts repaired by laser cladding, a three-factor, three-level orthogonal experimental scheme was employed to clad Ni60 powder on thin-walled parts with a thickness of 3.5 mm. To measure the deformation of the thin-walled parts, a method of combining the meshing of the backs of the thin-walled parts and fixing one end of the parts during cladding was used. The effects of the powder feed rate, laser power, and scanning speed on the deformation of the thin-walled parts were studied via visual analysis and analysis of variance, and the process parameters that resulted in the minimum deformation were determined. The deformation process of the thin-walled parts and the causes of cladding stress were also studied, and the microstructure of the cladding layer with the minimum deformation was analyzed via scanning electron microscopy (SEM). The results reveal that the deformation of the thin-walled parts increased with the increase of laser power. The increases of the scanning speed and powder feed rate were found to reduce the deformation of thin-walled parts; the laser power was found to have a significant effect, and the powder feed rate was found to have no significant effect, on the deformation of thin-walled parts. The order of the influence of factors on the deformation of thin-walled parts from greatest to least was determined to be as follows: laser power > scanning speed > powder feed rate. The optimal parameters to obtain the minimum deformation and good metallurgical bonding of thin-walled parts were found to be a powder feed rate of 1.4 r/min, a laser power of 1100 W, and a scanning speed of 8 mm/s. From the bottom to the top, the crystal structure of the coating with the minimum deformation was found to be coarse dendrite, dendritic crystal, and equiaxed crystal.

Experimental Study of Forming Rene95 Alloy Parts by Laser Cladding

Experimental research and result analysis of laser cladding forming

Experimental Study of Laser Cladding Forming Iron-Based Alloys

Experiment on Injection Powder Laser Cladding Forming L-Alloy

Microstructure and Properties of Metal Components by Laser Cladding Rapid Forming

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Study on Single Pass Forming Process Parameters of Laser Cladding Iron-based Alloy

Study on the Deformation Control and Microstructures of Thin-Walled Parts Repaired by Laser Cladding

Improvement in mechanical properties of Rene 104 superalloy during laser additive manufacturing process

Modification and Fabrication of Metal Components with CO 2 Laser Cladding Forming

Laser Cladding Additive Manufacturing Of Fully Dense Metal Components And Investigations Of Cracking Control Technology

Research Status of Laser Cladding on Light Alloy

Laser Cladding Ni35A120Fe Intermetallic Coating for Resisting High-Temperature Oxidation and Hot Corrosion

Experimental Research and Engineering Application of Laser Cladding Reparations

Laser Direct Forming of Metal Components: Technical Characterizations

Experimental Study on the Laser Rapid Forming Repairing of 45 Steel and 2cr12 Components

Tailoring the Mechanical Properties of Laser Cladding-Deposited Ferrous Alloys with a Mixture of 410L Alloy and Fe–Cr–B–Si–Mo Alloy Powders

Cracking Behavior of Laser Cladding Forming Nickel Based Alloys

Effect of Cooling Method on Formability of Laser Cladding IN718 Alloy

Technological Research on Repairing the Damaged Copper Alloy Parts by Use of Laser Cladding

Investigation on the effect of laser remelting for laser cladding nickel based alloy