Abstract:Abstract In the deep drawing forming process of wheel disks, the wall thickness at the rounded corners tends to be thinned. Using DEFORM software analysis, two stages of the deep drawing forming process are used to study the wheel disk forming. A finite element model of deep drawing and forming was established based on the theoretical analysis of the deep drawing and forming process. The stress and strain field distribution during the forming process of the circular blank was simulated and analyzed. The analysis shows that different punch feed rates and friction coefficients greatly influence the thinning rate and forming load of the wheel forming. The thinning rate reached 15.4% when the punch feed rate was 180 mm/s. The maximum forming load increases with the increase of friction coefficient, and the total forming load reaches 424 kN when the friction coefficient is 0.20. The effect of r p /t 0 and r d /t 0 on the wall thickness of the second pass forming was also analyzed. The results show that when r p /t 0 is 1.6~2.4 and rd/t0 is 2~3, the minimum wall thickness is larger, ΔX is also the smallest, and the forming quality is the best. The optimal set of parameters was obtained: punch feed rate of 120 mm/s, friction coefficient of 0.12, and r p /t 0 of 2.4. Physical tests were conducted on the self-designed forming machine, and the results were consistent with the simulation results, which verified the feasibility of the forming solution.

Study on the Influence of the Wheel Angular Velocity on the Continuous Extrusion Forming Process

STUDY ON TEMPERATURE FIELD OF CONTINUOUS EXTRUSION FORMING PROCESS

Frictional Model in Computer Simulation of Continuous Extrusion Forming Process

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Study on Deep drawing Forming Process of Wheel Disks

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

The Numerical Simulation about Cold Extrusion of Automotive Wheel Hub Bearing Rings

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Research on Hot Forging Process of C-Grade Steel Train Wheel by Fem

Influence of Process Parameters on Wedging-Spinning of Conical Cup Parts with Bottom Flanges

Numerical and Experimental Analysis of Deformation Behaviors and Microstructure Evolution in the Thread Rolling Process

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

The Importance of Forming Parameters on Rolling Process and the Performances of Component in Forming Long Threads

NUMERICAL SIMULATION AND EXPERIMENTATION CUP-SHAPED THIN-WALLED INNER RECTANGULAR GEAR FORMED BY SPINNING

Finite Element Analysis of Rotating Container in Extrusion Process

Thermal and mechanical behavior of casting copper alloy wheel during wheel and belt continuous casting process

Research On Influence Of Process Parameters On Sheet Metal Extrusion Force

Experimental study on the forming process of spline by frequency and amplitude modulated axial vibration extrusion

Research on the Influence of Main Spinning Process Parameters on the Forming Quality of 20 Steel by Strong Spinning

The Design and Simulation of Vibrate Impact Extrusion Die