Abstract:To take full advantages of Wide Bandgap power semiconductor devices, breakthroughs on power module development are heavily explored nowadays. This paper introduces a 1.2kV SiC half bridge intelligent power module utilizing 80μm flexible epoxy-resin as substrates instead of traditional Direct-bonded Copper, for better thermal-stress management and lower cost. The investigation on the flexible epoxy-resin material indicates that it has low leakage current even at 250 °C, and high thermal conductivity up to 8 W/mK. No bonding wires are applied in the half bridge power module, instead, double-side solderable SiC MOSFET and diodes are fabricated and utilized for low parasitics and double-side cooling function. To further decrease the entire parasitic inductance on the power loop, a “Stack Structure” is proposed in this work to vertically connect highside and lowside switches with lower interconnection path than traditional power module technology. Simulation indicates that the parasitic inductance on the power loop is less than 1.5 nH. More functionality is achieved by integrating the main power stage with gate driver circuits. Digital isolations are also included in the half bridge module, together with a Low Dropout regulator to eliminate the numbers of auxiliary power supply required by the power module. The size of the entire module is about 35mm × 15mm ×7mm. Electrical simulations and measurements, including leakage current, parasitic extractions, device characteristics, verified that the designed module can work properly with no degradation on the SiC devices, with 12ns turn-off and 48ns turn-on at 800V bus voltage, and 0.63 mJ, 0.23 mJ as turn-on and turn-off loss, respectively.

Realization of a Low-Side Device with High Speed and Low Power Dissipation in Half-Bridge Power Output Section

Igbt With Dynamic Controlled Anode-Short Used In Power Ic

Reverse Conducting Double Gate Lateral Insulated Gate Bipolar Transistor in Soi Based Technology

A High Speed IGBT Based on Dynamic Controlled Anode-Short

A High-Voltage “Quasi-P-ldmos” Using Electrons As Carriers in Drift Region Applied for SPIC

An Interdigitated Gan Mis-Hemt/Sbd Normally-Off Power Switching Device With Low On-Resistance And Low Reverse Conduction Loss

Characterization of a Bare-die SiC-based, Wirebond-less, Integrated Half-bridge with Multi-functional Bus-Bars

Design Of Dual-Gate Superjunction Igbt Towards Fully Conductivity-Modulated Bipolar Conduction And Near-Unipolar Turn-Off

High Performance GaN-based Monolithic Bidirectional Switch Using Diode Bridges

A New LDMOS/LIGBT Hybrid Structure In SPIC

A Dual-Gate and Dielectric-Inserted Lateral Trench Insulated Gate Bipolar Transistor on a Silicon-on-insulator Substrate

A High-Speed Si-Based Power Transistor With Bipolar-Assisted Gate Discharging Behavior

An Improved SiC MOSFET-gate Driver Integrated Power Module with Ultra Low Stray Inductances

Novel High-Voltage, High-Side and Low-Side Power Devices with a Single Control Signal

High Power High Frequency Half-Wave-mode ZCT-PWM Full Bridge DC/DC Converter

Novel Low-Side/High-Side Gate Drive and Supply With Minimum Footprint, High Power Density, and Low Cost for Silicon and Wide-Bandgap Transistors

A New High-Voltage Level-Shifting Circuit for Half-Bridge Power Ics

Low Turn-Off Loss Lateral Insulated Gate Bipolar Transistor with Double Deep P-Regions

High voltage low side and high side power devices based on VLD technique

Flexible Epoxy Resin Substrate Based 1.2 Kv SiC Half Bridge Module with Ultra-low Parasitics and High Functionality

A 400-V Half Bridge Gate Driver for Normally-off GaN HEMTs with Effective dv/dt Control and High dv/dt Immunity