Abstract:The necessity for compact and relatively low cost x-ray sources with monochromaticity, continuous tunability of x-ray energy, high spatial coherence, straightforward polarization control, and high brightness has led to the rapid development of Thomson scattering x-ray sources. To meet the requirement of in-situ monochromatic computed tomography (CT) for large-scale and/or high-attenuation materials based on this type of x-ray source, there is an increasing demand for effective algorithms to correct the energy-angle correlation. In this paper, we take advantage of the parametrization of the x-ray attenuation coefficient to resolve this problem. The linear attenuation coefficient of a material can be decomposed into a linear combination of the energy-dependent photoelectric and Compton cross-sections in the keV energy regime without K-edge discontinuities, and the line integrals of the decomposition coefficients of the above two parts can be determined by performing two spectrally different measurements. After that, the line integral of the linear attenuation coefficient of an imaging object at a certain interested energy can be derived through the above parametrization formula, and monochromatic CT can be reconstructed at this energy using traditional reconstruction methods, e.g., filtered back projection or algebraic reconstruction technique. Not only can monochromatic CT be realized, but also the distributions of the effective atomic number and electron density of the imaging object can be retrieved at the expense of dual-energy CT scan. Simulation results validate our proposal and will be shown in this paper. Our results will further expand the scope of application for Thomson scattering x-ray sources.

Micro-focus X-ray for Density Analytic Imaging Method and Non-Linear Correction Technique

A Simulation Study on the Flash X-Ray Spectra Spatial Distribution

The Study of Energy Subtraction Imaging Method with Microfocus X-ray Based on Non-linear Correction

A scatter correction method for Multi-MeV Flash Radiography

High-Resolution Scanning X-ray Diffraction Microscopy

Scanning parameter measurement and projected image correction for microfocus X-ray imaging system

An Experimental Study of Dual-Energy CT Imaging Using Synchrotron Radiation

Quantitative dual-energy micro-CT with a photon-counting detector for material science and non-destructive testing

Experimental Demonstration of X-Ray Fluorescence CT Using a Spatially Distributed Multi-Beam X-Ray Source

Improvements in Micro-CT Method for Characterizing X-ray Monocapillary Optics

Correcting directional dark-field x-ray imaging artefacts using position-dependent image deblurring and attenuation removal

Dual Energy CT Imaging in Cone-Beam Micro-Ct for Improved Attenuation Coefficient Measurement

Design and characterization of high energy micro-CT with a laser-based X-ray source

Research on the Influence of X-ray Phase Contrast Imaging Parameters with Micro-focus Source

Dual-energy CT Imaging Method Using Synchrotron Radiation

Improving Spatial Resolution and Correcting Surface Topography in Portable Macro-XRF Imaging Devices

Energy-angle Correlation Correction Algorithm for Monochromatic Computed Tomography Based on Thomson Scattering X-ray Source

Preliminary Study Of Quantitative X-Ray Spectral Imaging With Spectral Deconvolution

Coherent X-ray Imaging Technology

Preliminary Research on Laser Plasma Accelerator based Inverse Compton Scattering X-ray Imaging

X-ray Phase Contrast Imaging and Simulation in Near Field