Abstract:Purpose: The appearance of x-ray luminescence computed tomography (XLCT) opens new possibilities to perform molecular imaging by x ray. In the previous XLCT system, the sample was irradiated by a sequence of narrow x-ray beams and the x-ray luminescence was measured by a highly sensitive charge coupled device (CCD) camera. This resulted in a relatively long sampling time and relatively low utilization of the x-ray beam. In this paper, a novel cone beam x-ray luminescence computed tomography strategy is proposed, which can fully utilize the x-ray dose and shorten the scanning time. The imaging model and reconstruction method are described. The validity of the imaging strategy has been studied in this paper.Methods: In the cone beam XLCT system, the cone beam x ray was adopted to illuminate the sample and a highly sensitive CCD camera was utilized to acquire luminescent photons emitted from the sample. Photons scattering in biological tissues makes it an ill-posed problem to reconstruct the 3D distribution of the x-ray luminescent sample in the cone beam XLCT. In order to overcome this issue, the authors used the diffusion approximation model to describe the photon propagation in tissues, and employed the sparse regularization method for reconstruction. An incomplete variables truncated conjugate gradient method and permissible region strategy were used for reconstruction. Meanwhile, traditional x-ray CT imaging could also be performed in this system. The x-ray attenuation effect has been considered in their imaging model, which is helpful in improving the reconstruction accuracy.Results: First, simulation experiments with cylinder phantoms were carried out to illustrate the validity of the proposed compensated method. The experimental results showed that the location error of the compensated algorithm was smaller than that of the uncompensated method. The permissible region strategy was applied and reduced the reconstruction error to less than 2 mm. The robustness and stability were then evaluated from different view numbers, different regularization parameters, different measurement noise levels, and optical parameters mismatch. The reconstruction results showed that the settings had a small effect on the reconstruction. The nonhomogeneous phantom simulation was also carried out to simulate a more complex experimental situation and evaluated their proposed method. Second, the physical cylinder phantom experiments further showed similar results in their prototype XLCT system. With the discussion of the above experiments, it was shown that the proposed method is feasible to the general case and actual experiments.Conclusions: Utilizing numerical simulation and physical experiments, the authors demonstrated the validity of the new cone beam XLCT method. Furthermore, compared with the previous narrow beam XLCT, the cone beam XLCT could more fully utilize the x-ray dose and the scanning time would be shortened greatly. The study of both simulation experiments and physical phantom experiments indicated that the proposed method was feasible to the general case and actual experiments. (C) 2013 American Association of Physicists in Medicine.

Improvements in Micro-CT Method for Characterizing X-ray Monocapillary Optics

Characterizing the Inner Surface of Parabolic Monocapillary with Contrast-Enhanced Micro-Ct Technology and Ray-Tracing Computing Method

Optimization of Image Quality and Acquisition Time for Lab-Based X-ray Microtomography Using an Iterative Reconstruction Algorithm

Fast X-ray micro-tomography for low-Z materials

Region-of-interest micro-focus computed tomography based on an all-optical inverse Compton scattering source

Region-of-interest micro-focus CT based on an all-optical inverse Compton scattering source

Design, Optimization and Testing of a Multi-Beam Micro-Ct Scanner Based on Multi-Beam Field Emission X-Ray Technology

Spatial-resolution Enhancement in Micro-Ct

Method of Sparse-View Coded-Aperture X-Ray Diffraction Tomography

Micro Cone-Beam CT Scanner Based on X-ray Polycapillary Optics

Preliminary Research on Laser Plasma Accelerator based Inverse Compton Scattering X-ray Imaging

High-energy High-Dose Microfocus X-ray Computed Tomography Driven by High-Average-current Photo-Injector.

Cone Beam X-Ray Luminescence Computed Tomography: a Feasibility Study.

Multiple Source Translation Micro-CT Improves Both Field-of-View and Spatial Resolution

Investigation of sparse data mouse imaging using micro-CT with a carbon-nanotube-based X-ray source

Multi-mounted X-ray Cone-Beam Computed Tomography

Dual Energy CT Imaging in Cone-Beam Micro-Ct for Improved Attenuation Coefficient Measurement

Design and characterization of high energy micro-CT with a laser-based X-ray source

Optimization of reconstructed quality of hard x-ray phase microtomography

A Micro-Ct System For Little Animal Imaging

Improvements to conventional X-ray tube-based cone-beam computed tomography system