Abstract:The effect of partial substitution of Co for Ni on the structure and electrochemical properties of the thus formed La2Mg(Ni1−xCox)9 (x = 0.1–0.5) quaternary alloys was investigated. All alloys are consisted of a main phase with hexagonal PuNi3-type structure and a few impurity phases (mainly La2Ni7 and LaNi). The increase of Co content in the alloys leads to an increase in both the cell volume and the hydride stability, and leads to a noticeable decrease in cell volume expansion rate (ΔV/V) on hydriding. The discharge capacity of the alloys at 50mA/g increases slightly with the increase of Co content and passes though a maximum of 404.5mAh/g at x = 0.2. As the Co content increases, the high-rate dischargeability of the alloy electrodes at 800mA/g (HRD800) decreases sharply from 72.8 (x = 0) to 24.5% (x = 0.5), yet the decrease of HRD800 of the alloy electrodes with lower Co substitution (with x ≤ 0.2) is much milder. The slower decrease of HRD800 (from 72.8 to 64.2%) of the alloys with x from 0 to 0.2 is mainly attributed to the decrease of eletrocatalytic activity for charge-transfer reaction, the more rapid decrease of the alloys with x > 0.2 is mainly attributed to the lowering of the hydrogen diffusion rate in the bulk of alloy. The cycling capacity retention rate (S100) of the alloys increase greatly with increasing of Co content, increasing from 60.2% for the alloy with x = 0 to a much higher value of 87.9% for the alloy with x = 0.5. The improvement in cycling stability is attributed to the lower cell volume expansion on hydriding.

Surface Modification for La1-Xcex(Nicomnal)(5) Hydride Electrode by Hot Charging in Potassium Borohydride Solution

Surface Modification and Preparation Technique for La_(1- X) Ce_x (nicomnal)_5 Hydrogen Storage Alloy Electrode

New Surface Modification for La_(1-x) Ce_x(NiCoMnAl)_5 Hydrogen Storage Alloys: KBH_4 Alkaline Aqueous Solution-Hot Charging Treatment

Activation behavior of Zr0.7Ti0.3Cr0.3Mn0.3V0.4Ni alloy electrode modified by the hot-charging treatment

Electrochemical Properties of La0.9Sm0.1Ni(5.0−x)Cox (x=2.0, 2.5, 3.0) Hydride Electrode Alloys

Improvement in electrochemical performances of mm(nicomnal)5 electrodes by surface modification

Surface treatment for hydrogen storage alloy of nickel/metal hydride battery

Effects of Ca-substitution and surface treatment on electrochemical performances of Ml1.0-xCaxNi4.0Co0.6Al0.4 hydrogen storage alloy electrodes

The structural and electrochemical properties of La2Mg(Ni0.8-xCo0.2Alx)9 (x = 0-0.03) hydrogen storage electrode alloys

Effect of Co Substitution for Ni on the Structural and Electrochemical Properties of La2Mg(Ni1−xCox)9 (x = 0.1–0.5) Hydrogen Storage Electrode Alloys

Cyclic voltammetry and electrochemical impedance of MmNi3.6Co0.7Mn0.4Al0.3 alloy electrode before and after treatment with a hot alkaline solution containing reducing agent

Improved electrochemical performance of AB2-type metal hydride electrodes activated by the hot-charging process

Effects of surface treatment on performances of metal hydride electrodes and Ni/MH batteries

A study on the structure and electrochemical properties of La 2Mg(Ni0.95M0.05)9 (M = Co, Mn, Fe, Al, Cu, Sn) hydrogen storage electrode alloys

Influence of Annealing Treatment on Microstructure and Cycling Stability of La-Rich Ml(Nicomnal)(5) Alloy Electrode for Ni/Mh Batteries

Effect of magnetization treatment on the electrochemical properties of La0.9Sm0.1Ni2.0Co3.0 electrode alloy

Effects of Surface Modification on the Electrode Behavior of Ball-Milled La2Mg17 + 200 Wt% Ni Composite in Alkaline Solution

PHASE STRUCTURE AND ELECTROCHEMICAL PROPERTIES OF La-Mg-Ni SYSTEM AB_3 TYPE HYDROGEN STORAGE ELECTRODE ALLOYS

Electrochemical properties of Ml(NiCoMnCu)5 used as an alkaline fuel cell anode

Electrochemical Investigations of Activation and Degradation of Hydrogen Storage Alloy Electrodes in Sealed Ni/MH Battery

Surface treatments of hydrogen storage alloy improve charge-discharge performances of Ni/MH battery