Abstract:A precursor CuO/ZnO/Al2O3 catalyst for methanol synthesis has been prepared at room temperature by introducing a ternary salt solution into the excess of sodium carbonate solution following the reverse co-precipitation method. The catalyst was tested for the synthesis of methanol from synthesis gas. The composition (vol. %) has been presented: CO, 22; CO2, 5.8; N2, 5.5; H2, balance. The methanol productivity was recorded to be 2.7 kg kgcat–1 h–1 at a temperature of 260 °С, a pressure of 3 MPa, and a space velocity of 61,700 l (kgcat)–1 h–1. The possibility of regenerating the activity of a catalyst subjected to conditions of artificial aging (overheating in a syngas environment) has been tested: approximately 92% of the initial activity could be restored. Physicochemical studies were conducted using the thermogravimetric analysis (TGA), Fourier-transform infrared spectroscopy (FTIR), the scanning electron microscopy (SEM), and the X-ray diffraction (XRD) techniques using the Cu, Zn, and Al oxides obtained following the co-precipitation method. X-ray studies revealed that an amorphous phase was obtained from the Al oxide that was synthesized following both the direct and reverse co-precipitation methods. The calcination temperature was 300 °C. Individual oxides of Cu and Zn obtained following the reverse co-precipitation method form crystalline phases when calcined at 300 °C. When all three ingredients are present, calcination of the sample at 300 °C helps obtain an X-ray amorphous structure of the catalyst characterized by a high specific surface area. High-temperature carbonates are formed from samples prepared using a ternary mixture of nitrate salts when these are calcined at 300 °C.

Preparation and Characterization of Cu-Cr-M-O Catalyst for Synthesis of Methanol and Methyl Formate at Low Temperature in Slurry Phase

INVESTIGATION ON ULTRAFINE Cu-Cr OXIDE CATALYST FOR SYNTHESIS OF METHANOL AND METHYL FORMATE AT LOW PRESSURE AND TEMPERATURE IN LIQUID PHASE Ⅰ . Effect of Preparation Conditions on the Performance of Catalyst

INVESTIGATION ON ULTRAFINE Cu-Cr OXIDE CATALYSTS FOR SYNTHESIS OF METHANOL AND METHYL FORMATE AT LOW PRESSURE AND TEMPERATURE IN LIQUID PHASE——II.Effect of Mn Contents on the MF Selectivity of Catalysts

Highly Dispersed Crox Nanoparticles Modified Nazsm-5 for Lower Temperature Dehydration of Methanol to Dimethyl Ether

Concurrent synthesis of methanol and methyl formate catalyzed by copper-based catalysts - II. Influences of solvents and H2/CO mole ratios

Highly Dispersed CrOx Nanoparticle-Modified NaZSM-5 for Dehydration of Methanol to Dimethyl Ether

Surface Properties of CuO/ZnO/Al_2O_3 Catalyst for Methanol Synthesis in Slurry Reactor

Preparation of Mesoporous Cu/ZnO Catalyst and Its Application in Low-Temperature Methanol Synthesis

Preparation of CuO/ZnO/Al2O3 Catalysts for Methanol Synthesis Using Parallel-Slurry-mixing Method

Concurrent synthesis of methanol and methyl formate catalyzed by copper-based catalysts in a slurry phase

Influence of the Calcination on the Activity and Stability of the Cu/ZnO/Al2O3 Catalyst in Liquid Phase Methanol Synthesis

Methanol and methyl formate synthesis from synthesis gas over cuprous chloride catalyst in liquid phase

Preparing methods of CuO/ZnO/Al2O3 catalysts for the synthesis of methanol

Alcohol Solvent Assisted Synthesis of Metallic and Metal Oxide Catalysts: As-Prepared Cu/ZnO/Al 2 O 3 Catalysts for Low-Temperature Methanol Synthesis with an Ultrahigh Yield

PREPARATION OF CuO/ZnO CATALYST FOR METHANOL SYNTHESIS BY CARBON DIOXIDE HYDROGENATION I. Preparation Methods

STUDY OF Cu Mu CATALYST FOR THE SYNTHESIS OF METHYL FORMATE AND METHANOL FROM SYNTHESIS GAS

A High Activity Cu/ZnO/Al2O3 Catalyst for Methanol Synthesis: Preparation and Catalytic Properties

Effective Cu/ZnO/Al2O3 Catalyst for Methanol Production: Synthesis, Activation, Catalytic Performance, and Regeneration

Cuo/Zno/Al2o3 Catalyst Prepared by Mechanical-Force-Driven Solid-State Ion Exchange and Its Excellent Catalytic Activity under Internal Cooling Condition

Concurrent synthesis of methanol and methyl formate catalyzed by copper-based catalysts I. Influences of temperature and pressure

Complete Liquid Phase Preparation and Characterization of CuZnAlSi Catalysts for DME Synthesis in Slurry Reactor