Abstract:Hydrotreating catalytic fast pyrolysis (CFP) oil is a promising technology for producing diesel fuel from lignocellulosic biomass to reduce greenhouse gas emissions. Compared to fast pyrolysis oil, CFP oils exhibit a low oxygen content and high stability and can be processed in a single hydrotreater. Two strategies were evaluated for biogenic carbon-incorporation into the diesel production: co-hydrotreating of CFP oil with straight run diesel (SRD) and standalone hydrotreating of CFP oil. Co-hydrotreating 80 vol% SRD and 20 vol% CFP oil at typical conditions of SRD hydrotreating employed at petroleum refineries (325 °C, 55 bar) over sulfided NiMo and CoMo catalysts led to products with desirable fuel properties, including indicated cetane numbers (ICNs) of 42-45. While oxygen was efficiently removed from products by co-hydrotreating over both catalysts, NiMo resulted in a higher formation of cycloalkanes and a higher ICN. Over 90% of the carbon in CFP oil was incorporated into the hydrotreated product as determined by C-14 analysis. Standalone hydrotreating of CFP oil was performed at 385 °C, 125 bar over NiMo in a single hydrotreating reactor with a two-zone configuration consisting of an initial zone from 150°C to the hydrotreating temperature followed by an isothermal zone. Compared to previously reported isothermal hydrotreating, the new hydrotreating configuration resulted in a similar carbon efficiency but a higher fraction (95 vs. 84 wt%) boiling in the fuel range and significantly improved fuel properties (cetane number of 45 vs. 24). Both co-hydrotreating and standalone hydrotreating of CFP oil strategies showed great potential to produce sustainable diesel fuel with properties meeting standard diesel specifications in an existing petroleum refinery and a customized biorefinery, respectively.

MCI - A new hydrotreating technology for upgrading LCO

MCI TECHNOLOGY FOR IMPROVING CETANE NUMBER OF DIESEL OIL

Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components

Co-hydrotreating of Used Engine Oil and the Low-Boiling Fraction of Bio-Oil Blends for the Production of Liquid Fuel

Commercial Analysis of Catalytic Hydroprocessing Technologies in Producing Diesel and Gasoline by Light Cycle Oil

RICH®-II technology for improving cetane number of FCC-LCO

Combined mild hydrocracking and fluid catalytic cracking process for efficient conversion of light cycle oil into high-quality gasoline

FCC-Hydrotreating Synergy Improve Refinery Economics

Hydroprocessing/upgrading process integration to meet divers demands of clean diesel production

A NEW GENERATION CATALYST RN 10 FOR DISTILLATE HYDROTREATING

STUDY ON PROCESSING CONDITIONS OF A NEW GENERATION HYDRO-UPGRADING CATALYST FOR FCC LCO AND ITS COMMERCIAL APPLICATION

Commercial Application of a New FHC Hydrocracking Technology

Diesel Production via Standalone and Co-Hydrotreating of Catalytic Fast Pyrolysis Oil

Direct Production of High Octane Gasoline and ULSD Blend Stocks by LCO Hydrocracking

Selective hydrocracking of light cycle oil into high-octane gasoline over bi-functional catalysts

A NEW INTEGRATION PROCESS OF RESIDUE HYDROTREATING COMBINED WITH CATALYTIC CRACKING

Optimizing Both the CoMo/Al2O3 Catalyst and the Technology for Selectivity Enhancement in the Hydrodesulfurization of FCC Gasoline

Engineering Dual Bed Hydrocracking Catalyst Towards Enhanced High-Octane Gasoline Generation from Light Cycle Oil

DEVELOPMENT OF MID-PRESSURE HYDROCRACKING FOR MORE MIDDLE DISTILLATES

Novel Magnetic Carbon Supported Molybdenum Disulfide Catalyst and Its Application in Residue Upgrading

Upgrading of Light Cycle Oil to High-Octane Gasoline Through Selective Hydrocracking over Non-Noble Metal Bifunctional Catalysts