Effect of grain thickness and T 1 precipitate on the strength anisotropy of Al-4.0Cu-1.0Li-0.4Mg-0.4Ag-xZr alloys under different heat treatment
Zhen-zhen Liu,San-xi Deng,Mao Rao,Ji-rong Que,Jin-feng Li,Dan-yang Liu
DOI: https://doi.org/10.1016/j.jallcom.2023.172105
IF: 6.2
2023-09-15
Journal of Alloys and Compounds
Abstract:The influences of grain thickness and T 1 precipitate on the strength anisotropy of extruded Al-4.0Cu-1.0Li-0.4Mg-0.4Ag-xZr alloys (x = 0, 0.1, and 0.14 wt%) were investigated. The alloys were subjected to different heat-treatment conditions to obtain distinct grain morphologies adjusted by different Zr content and to induce T 1 precipitate. The results demonstrated that grain morphology, particularly the grain thickness influenced by various Zr content, is the primary factor affecting strength anisotropy under different heat treatment conditions. In solution heat-treated alloys (SHT), reduced grain thickness, extended length of low-angle grain boundaries (LAGBs), and more uniformly distributed dislocations due to increasing Zr content led to a decrease in strength anisotropy. Conversely, in T6-aged alloys, the combined interaction between T 1 precipitate and substructures in thinner grains with more LAGBs may aggravate the degree of strength anisotropy. In addition, the T 1 precipitate further amplified the anisotropy induced by the Brass texture component also increasing strength anisotropy. The findings highlight the significance of grain thickness, LAGBs length, dislocation distribution, and the interaction between T 1 precipitate and these factors in influencing the strength anisotropy of Al-Li alloys. Moreover, after solution heat treatment, adding 0.1 wt% Zr in the alloy reinforced the intensity of β-fiber texture while adding 0.14 wt% Zr wakened the β-fiber texture intensity due to the particle-simulated recrystallization process.
materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering